HobbyZone J-7 commando Instructions

Get ready to rumble with your J-7 Commando Cross Country Assault Vehicle. But before the fun begins,
it's very important that you read these instuctions completely and follow the directions carefully.
STEP 1. Charge battery
• Insert 6V battery into charger.
• Plug charger into 110V AC wall outlet.
• The battery should be charged for 3 hours prior to first use.
Subsequent charges should also be 3 hours.
• When the battery becomes warm, it is fully charged.
Stop charging immediately.
NOTE: For best battery
performance, deplete each
charge before re-charging.
Wall Charger
When the battery is low,
run your vehicle until the
motor stops completely.
Your battery is now
depleted and can 6V Rechargeable
be recharged. Ni-Cd Battery
INSTRUCTIONS
®
110V AC
Wall Outlet
Left Stick
(controls left wheels)
Transmitter
6V Rechargeable Ni-Cd Battery
STEP 2. Install battery in transmitter
• Open the battery cover on the back of the transmitter.
• Check for positive and negative poles, then install 9V battery pack.
• Close cover.
NOTE: You'll get about 8 hours of operation with this battery—
it is not rechargeable.
Antenna
Right Stick
(control right wheels)
9V
Transmitter
Battery
Wall Charger
9V Transmitter
Battery
Back of Transmitter