Programming the Weekly Timers
The following is a general outline of the setting options and procedures avaliable when
programming the weekly timers.
Note: Before programming the current time and day must be set.
The weekly timers can be easily programmed by following the steps illustrated below:
Press the "Timers"
1
button once to
activate the timer
programming mode.
Timers
2
Select the day or
group of days you
wish to program by
pressing the "up" and
"down" buttons:
Choose from the
following options:
Mo Tu We Th Fr Sa Su
Mo Tu We Th Fr
Sa Su
or each day of the
week in turn.
If a group of days is
chosen, the times and
temperatures selected
in steps 3 → 5 will
automatically apply
for those days.
Press the "Select"
button to confirm your
choice.
Select
6
3
Repeat steps
7
Press the "Timers" button again to confirm your program and lock in all settings.
3
Select the period you wish
to program by pressing
the "up" and "down"
buttons:
Periods 1 → 4 will
automatically appear in
order as you follow this
programing sequence, so
you may not need to
manually select a timer
period.
Press the "Select" button
to confirm your choice.
Select
5
→
for periods 1 through to 4 until you are satisfied with all the settings.
Rinnai Corporation EX17 / EX22 Manual
Set
am
Mo Tu We Th Fr Sa Su
1
2
3
4 OFF
4
Set the start time for this
period by pressing the
"up" and "down"buttons:
The time will move up or
down in 10 minute
increments.
Each period must be set
to a later time than the
period before it.
No period can be set
past 11:50 pm, as this is
the end of the 24 hour
program.
Press the "Select"button
to confirm the time.
Select
Auto
Frost
Man
Override
Select
Prog
Clock
Temp R
5
Set the temperature
you want for this period
by pressing the "up"
and "down" buttons:
Choose from the
following temperature
settings:
H(high, maximum fire)
80° F →60° F
L(low, minimum fire)
- - (OFF)
If you want heat during
this period, choose a
temperature.
If you do not want heat,
choose the OFF setting.
Press the "Select" button
to confirm the
temperature setting.
Select
11