NuTone QTXN100HL Read And Save These Instructions

NuTone QTXN100HL Read And Save These Instructions

Qtxn series heater/fan/ lights
Table of Contents

Advertisement

Available languages

Available languages

QTXN SERIES
HEATER / FAN / LIGHTS
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the ser-
vice disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhaust-
ing of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Acceptable for use over a tub or shower when connected to a
GFCI (Ground Fault Interrupter) - protected branch circuit.
8. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
2. This product is designed for ceiling installation only - in ceil-
0
ings up to a 45
pitch. Ductwork must point up. DO NOT
MOUNT THIS PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbal-
anced impellers, use the cardboard protector (provided) to
keep drywall spray, construction dust, etc. off power unit.
4. Please read specification label on product for further infor-
mation and requirements.
Installer: Leave this manual with the homeowner.
®
MODELS QTXN100HL • QTXN110HL
CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive ap-
pearance - lower or remove grille and vacuum interior of unit
with the dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If
the motor bearings are making excessive or unusual noises,
replace the motor with the exact service motor. The impeller
should also be replaced.
Replace light bulbs with (2) 60-Watt (maximum) incandescent
light bulbs and (1) 7-Watt night light bulb.
OPERATION
Use a 4-Function Control to operate the heater, fan, light, and
night light separately.
See "Connect Wiring" for details.
WARRANTY
NUTONE ONE YEAR LIMITED WARRANTY
NuTone warrants to the original consumer purchaser of its products that such products
will be free from defects in materials or workmanship for a period of one year from the
date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MER-
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this one-year period, NuTone will, at its option, repair or replace, without charge,
any product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS
AND TUBES. This warranty does not cover (a) normal maintenance and service or (b)
any products or parts which have been subject to misuse, negligence, accident, im-
proper maintenance or repair (other than by NuTone), faulty installation or installation
contrary to recommended installation instructions.
The duration of an implied warranty is limited to the one-year period as specified for the
express warranty. Some states do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.
NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE'S OPTION, SHALL
BE THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS WAR-
RANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL
OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PROD-
UCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify NuTone at the address or telephone
number stated below, (b) give the model number and part identification and (c) de-
scribe the nature of any defect in the product or part. At the time of requesting warranty
service, you must present evidence of the original purchase date.
NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227 (1-800-543-8687)
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for NuTone QTXN100HL

  • Page 1 This warranty supersedes all prior warranties. keep drywall spray, construction dust, etc. off power unit. To qualify for warranty service, you must (a) notify NuTone at the address or telephone number stated below, (b) give the model number and part identification and (c) de- 4.
  • Page 2: Typical Installation

    MODELS QTXN100HL • QTXN110HL ® Page 2 TYPICAL INSTALLATION INSTALLATION 1. Insert CEILING mounting MOUNTING JOIST, TRUSS, CALES CHANNELS brackets. OR I-JOISTS Slide the (4) mounting brackets into the HOUSING channels on each end of the housing. CEILING GRILLE MATERIAL 2.
  • Page 3: Connect Wiring

    MODELS QTXN100HL • QTXN110HL ® Page 3 CONNECT WIRING INSTALL GRILLE & BULBS 8. Plug-in light. WHITE TO WHITE Hold grille assembly up RED TO BLACK near housing. Connect light TOP / BACK BLACK plug from grille OF HOUSING TO YELLOW...
  • Page 4: Service Parts

    MODELS QTXN100HL • QTXN110HL ® Page 4 SERVICE PARTS Key No. Part No. Description 97016470 Housing 98007763 Slide Channel (2 req.) 98003036 Support Angle (4 req.) 97016450 Duct Connector 99170245 Screw #8-18 X .375 (8 req.) 93260454 Nut, Sheet Metal #8-18 (Partition) (2 req.)
  • Page 5 5. Al cortar o perforar a través de la pared o del cielo raso, no dañe Durante el período de un año, y a su propio criterio, NuTone reparará o reemplazará, sin costo el cableado eléctrico ni otros servicios ocultos.
  • Page 6: Instalación Típica

    MODELOS QTXN100HL • QTXN110HL ® Página 6 INSTALACIÓN TÍPICA INSTALACIÓN 1. Inserte los soportes de CABLES DE IA DE TECO ELECTRICIDAD TIRANTE O montaje. RANURAS IA EN I DE MONTAJE Deslice los (4) soportes de montaje en las CUBIERTA ranuras en cada extremo de la cubierta.
  • Page 7: Conexión Eléctrica

    MODELOS QTXN100HL • QTXN110HL ® Página 7 CONEXIÓN ELÉCTRICA INSTALE LA REJILLA Y LOS FOCOS BLANCO ROJO CON BLANCO 8. Conecte el PARTE CON NEGRO SUPERIOR/ foco. PARTE Sostenga el POSTERIOR DE NEGRO CON conjunto de la LA CUBIERTA AMARILLO...
  • Page 8: Piezas De Repuesto

    MODELOS QTXN100HL • QTXN110HL ® Página 8 PIEZAS DE REPUESTO Clave No. Pieza No. Descripción 97016470 Cubierta 98007763 Ranura de deslizamiento (se req. 2) 98003036 Ángulo de soporte (se req. 4) 97016450 Conector del conducto 99170245 Tornillo, #8-18 x 0.375 (se req. 8) 93260454 Tuerca de chapa #8-18 (División)

This manual is also suitable for:

Qtxn110hl

Table of Contents