Bottle Preparation; Temperature Indicator Lights - Baby Brezza Formula Pro Instructions For Setup

Hide thumbs Also See for Formula Pro:
Table of Contents

Advertisement

Bottle Preparation

Follow the steps on these pages to prepare bottles with the Formula Pro®
1
Fill water to MAX line
Pour powder loosely and evenly into Powder Container. Never fill past the MAX line.
Never pack powder in the Powder Container or overfill.
Powder can be spread evenly with the 3 arms on the Powder Container Lid before closing.

Temperature Indicator Lights

Flashing Yellow means
water is heating.
Solid Green means
water is warm
and ready.
Flashing Yellow & Green
means water poured into
tank is too hot or too cold.
Bottle Preparation continued on next page
5
Fill powder container with powder
2
and close Lid
About water temperature
The heater in the Water Tank will warm the water and keep it warm as
long as the machine is powered on.
If you refill the Water Tank with cool or room temperature water and
need to use the machine right away, the machine can be used while
water is heating (flashing yellow light).
If you run the machine with cool or room temperature water, before
the water is warm and ready, always make sure formula is mixed
properly and check for clumps.
For quickest warming time, always fill the water tank with room
temperature or cool water. Flashing green & yellow lights mean the
water poured into in the Water Tank is too hot or too cold.
The machine will not work while the green & yellow lights flash.
If you don't want to wait long for the water to heat, do not fill with
water stored in the refrigerator.
Never fill Water Tank with hot water. If you boil water before using it
in the machine, let the water cool to body or room temperature before
pouring it into the Water Tank.
Bottle Preparation Continued
Select correct height for Drip
Short Bottle
Tray based on bottle height.
Lift up and pull out to remove.
Adjust the drip tray so the bottle is as close to the Funnel outlet as possible.
3
Push in and
down
to install.
This will make sure no formula spills outside of the bottle.
Select bottle size by pressing the ounce button.
4
With each push, the amount will increase 2 ounces.
Check level of mixed formula.
Machine will dispense formula
Level will appear higher
into bottle and stop when done.
7
6
Never remove Water Tank, Funnel or Powder Container while machine is in operation.
Always hold the bottle when feeding baby. Never prop the bottle up and leave your baby to feed unsupervised.
After baby stops feeding from bottle, discard any leftover formula mixture.
Tall Bottle
When desired ounce size is selected, press start
5
to dispense formula.
Check for clumps and shake
or stir the bottle if necessary.
Test temperature...
due to
added powder volume and/or
8
variance in bottle markings.
and feed baby.
...
6

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Formula Pro and is the answer not in the manual?

Table of Contents

Save PDF