Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual page 2

PLEASE READ THIS MANUAL BEFORE INSTALLING AND
MODEL 6000TRSI-AUC
IS AUSTRALIAN GAS ASSOCIATION APPROVED
FOR NATURAL GAS OR PROPANE AS A
BALANCED FLUE HEATER.
Refer to the appliance data plates for gas consump-
tions and pressures.
Installation of this appliance should only be carried
out by an authorized person in accordance with the
manufacturers instructions. All relevant codes and
regulations laid down by the gas fi tting authorities,
municipal building regulations, electrical wiring
regulations, and the requirements of the AGA Gas
Installation Code must be observed.
This appliance and its components are tested and
safe when installed in accordance with this Installa-
tion Manual. Report to your dealer any parts dam-
aged in shipment, specifi cally check glass condition.
The gas logs and fl ue system components are in
separate packages.
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fi re
hazard and will void the warranty. Save this manual for future reference.
Heat & Glo, a brand of Hearth & Home Technologies, Inc.
7571 215 th Street West, Lakeville, MN 55044
Copyright 2009 • Printed in U.S.A.
2
USING THIS APPLIANCE.
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. Q • 6/10
Read all instructions before starting installation and
follow these instructions carefully during installation
to ensure maximum benefi t and safety. Failure to
follow them will void your warranty and may pres-
ent a fi re hazard.
The Heat & Glo warranty will be voided by, and
Heat & Glo disclaims any responsibility for the fol-
lowing actions:
• Installation of any damaged heater or fl ue sys-
tem component
• Modifi cation of the heater or balanced fl ue sys-
tem installation other than as instructed by Heat
& Glo.
• Improper positioning of the gas logs or the glass
door
• Installation and/or use of any component part
not manufactured or approved by Heat & Glo,
not withstanding any independent testing
laboratory or other party approval of such com-
ponent part or accessory.