Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Storm RC Manuals
  4. Quadcopters
  5. X5 Ucav
  6. Instruction manual

Storm RC X5 Ucav Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the X5 Ucav and is the answer not in the manual?

Questions and answers

Related Manuals for Storm RC X5 Ucav

Summary of Contents for Storm RC X5 Ucav

  • Page 2 1.Introduction 2.General safety precautions and warings 3.Charging the flight battery 4.Table of contents 5.Transmitter 6.Description of switch location and function 7.Transmitter battery 8.LED indicates 9.Gps & compass calibration notes. 10.X5 flight LED indicator 11.Stability and Agility Mode control inputs 12.Unlock process 13.Stabilize Mode 14.Direction lock 15.Althold...
  • Page 4 Nose APM controller system Receiver Battery LED indicator for APM controller Rear system working status 1045 Rotor 1045 Rotor (R) Nose Rear 1045 Rotor (R) 1045 Rotor...
  • Page 5 Channel-7 Channel-8 Stabilize mode.0 0.Stabilize mode Altitude hold.1 1.GPS loiter Direction lock. 2 2.GPS RTL Bind Mode 1 Mode 2 Channel-7 Channel-8 Stabilize mode.0 0.Stabilize mode Altitude hold.1 1.GPS loiter Direction lock. 2 2.GPS RTL Throttle & Rudder Stick Elevator & Aileron Stick Bind Mode 1 Mode 2...

  • Page 6: Transmitter Battery

    7、Description of switch location and function： Sw1 location Sw2 location Function Stabilize mode Altitude hold Direction lock GPS loiter GPS RTL Rolling Tilting 8、Transmitter battery:...
  • Page 7 LED indicator for APM controller system working status...
  • Page 10 SW1&SW2 set at "0" SW1&SW2 set at "0" Pulled the rudder switch and hit the bottom right corner of the bottom until the red flashing LED to relese. Solid blue LED light indicate successful unlocking. Flashing red LED light indicate locking. The propeller can not rotate when controller system is locking.
  • Page 11 Sw1set at " 2" ,sw2 set at " 0" . Sw1set at " 1" ,sw2 set at " 0" .
  • Page 12 Sw1set at "0" ,sw2 set at "1". Sw1set at "0" ,sw2 set at "2".
  • Page 14 2.Move the Throttle & Rudder switch to the bottom right corner, after 12 seconds, quadcopter get into flight stabilized control calibration mode when Blue Green change flashing. And then take off the quadcopter, keep hovering, the calibration is finished when Gree LED stop fast flashing.