Operation And Configuration - Diginet DGEMSR360P2 User And Installation Manual

DIGINET ENERGY MANAGEMENT
6.

Operation and Configuration

Upon power-up the sensor performs an initialisation which will take approximately 45 secs. During this period the
relay will close and open forcing the connected load to turn on and off. Once the initialisation has completed,
normal operation commences at which full sensitivity is reached after a period of 5 mins.
When the presence sensor is powered and functional, green and red LEDs within the sensor head will indicate
mode/operation as defined in Table 2.
Table 2 – LED indicators for each of the operational conditions
Mode
Normal Operation
Walk Test Mode*
*Override mode is disabled during walk test mode.
The time delay and light level threshold settings are easily configured after installation by using the patented push
in-pop out mechanism as detailed in Figures 7 and 8.
Figure 7 - Press gently on the lens until a click is heard then release to access sensor adjustment sliders
Figure 8 - Press gently on the head until click is heard to return to normal operating position.
As shown in Figure 8, the adjustable sliders for time delay and light level threshold are accessed when the sensor
head is in the out position. Tables 3 and 4 detail the parameters for the time delay and ambient light level
adjustable settings.
Diginet Control Systems Pty Ltd
LED Indicator
Green LED OFF
Green LED ON
Red LED ON
Green LED "Flashing"
Red LED "Flashing"
Recessed Flush Mount 360
Condition
Ambient light below threshold setting
Ambient light above threshold setting
Manual override activated
Ambient light above threshold setting
Movement detected
o
PIR Presence Sensor
Page 8 of 16