Table of Contents
Advertisement
78
Error Messages
02D0 System cache error -
Cache disabled
02F0: CPU ID:
02F4: EISA CMOS not
writeable*
02F5: DMA Test Failed*
02F6: Software NMI
Failed*
02F7: Fail-Safe Timer NMI
Failed*
device Address Conflict
Allocation Error for: device
Failing Bits: nnnn*
Invalid System
Configuration Data
I/O device IRQ conflict
One or more I2O Block
Storage Devices were
excluded from the Setup
Boot Menu
Operating system not found
Corrective Action
RAM cache failed and BIOS disabled the cache. On older
boards, check the cache jumpers. You may have to
replace the cache. See your dealer. A disabled cache
slows system performance considerably.
CPU socket number for Multi-Processor error.
ServerBIOS2 test error: Cannot write to EISA CMOS.
ServerBIOS2 test error: Cannot write to extended DMA
(Direct Memory Access) registers.
ServerBIOS2 test error: Cannot generate software NMI
(Non-Maskable Interrupt).
ServerBIOS2 test error: Fail-Safe Timer takes too long.
Address conflict for specified device.
Run ISA or EISA Configuration Utility to resolve
resource conflict for the specified device.
The hex number nnnn is a map of the bits at the RAM
address which failed the memory test. Each 1 (one) in the
map indicates a failed bit. See errors 230, 231, or 232
above for offset address of the failure in System,
Extended, or Shadow memory.
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict error.
There was not enough room in the IPL table to display all
installed I2O block-storage devices.
Operating system cannot be located on either drive A: or
drive C:. Enter Setup and see if fixed disk and drive A:
are properly identified.
6 Troubleshooting
Advertisement
Table of Contents
