Sony UWP-D11 Operating Instructions Manual page 13

d RF (radio frequency input) indicator
Displays the RF input level using the following colors.
On (green): Input level is 25 dBμ or more.
On (red): Input level is 15 to 25 dBμ.
Off: Input level is 15 dBμ or lower.
* 0 dBμ = 1 μV
EMF
e Infrared transmitter port
Sends the set frequency and compander mode to the
transmitter.
f + or – button
Selects functions or values shown on the display.
g Battery compartment
Accepts two AA batteries (alkaline, nickel metal hydride,
or lithium batteries).
For details on how to insert batteries, see "Power
Supply" (page 14).
h Display section
A Audio input level meter
Displays the audio input level.
B Peak indicator
Lights up when the signal is 3 dB below the level at which
distortion begins as a warning of excessive input level.
C Battery level indicator
Displays the battery level. Displays "EXT" when power
is supplied from the USB connector.
For details, see "Battery level indicator" (page 15).
D RF level (reception level) indicator
Indicates the current reception level.
E Menu display section
Displays various functions. Press the + or – button to
switch functions.
For details, see "Configuration menu" (page 23).
i SET button
Adjusts displayed function settings and enters the
displayed value.
Holding down the SET button while turning on the power
turns the transmitter on without sending a signal
(transmission stopped mode).
j POWER button
Turns the power on/off.
Function Operation
Supply ON Press button for one second or longer
Supply OFF Press button until the indicator turns
off
k OUTPUT (audio output) connector (3.5-mm
diameter, stereo mini jack)
Connect one end of the supplied XLR-BMP conversion
output cable for the URX-P03 or the stereo mini plug-
BMP conversion cable here and the other end to the
microphone input on a camcorder, mixer, or amplifier. If
the microphone input connector on the connected device
is a stereo mini jack, connect the straight (BMP) plug to
the tuner and the L-shaped (stereo mini) plug to the
microphone input connector on the device.
Note
To prevent damaging the tuner, do not apply a voltage to
this connector from a microphone external power supply
or other source.
l USB connector (Micro B type)
Connect to a commercially available USB portable power
supply.
When the power is turned on, the unit operates with
power supplied by the USB portable power supply. When
nickel metal hydride batteries are inserted and the power
is turned off, the battery is charged by the USB portable
power supply.
Note
Alkaline batteries and lithium batteries cannot be
recharged.
m Auxiliary connector
Used to connect external accessories.
13
Name and Function of Parts