Ariston CD12TUK User Instruction Book page 13

Mounting the wooden panel onto the door
and inserting the machine into cabinets:
In the case where the machine must be shipped for final
installation after the wooden panel has been mounted, we
suggest leaving it in its original packaging. The packaging was
designed to make it possible to mount the wooden panel
onto the machine without removing it completely (see figures
below).
The wooden panel that covers the face of the machine must
not be less than 18 mm in thickness and can be hinged on
either the right or left. For the sake of practicality when using
the machine, we recommend that the panel be hinged on the
same side as the door for the machine itself - the left.
c h e ri a
la v a b ia n
m a c h in e
w a s h in g
à la v e r
m a c h in e
a s c h in e
w a s c h m
rta
La to po
e
Do or sid
rte
Co te po
ite
Tu r se
A
C
E
GB
Door Mounting Accessories
B
No. 6 type A self-threading screws, l =13 mm
No. 2 type F self-threading screws, l =9 mm
No. 2 type B metric, countersunk screws, l =25; for fastening
the magnet plate to the cabinet
D
No. 4 type C metric screws, l =15 mm; for mounting the hinge
supports to the cabinet
No. 4 type D metric screws, l =7 mm; for mounting the hinges
on the supports
Mounting the Parts onto the Face of the
Machine
c h e ri a
la v a b ia n
m a c h in e
w a s h in g
à la v e r
·
m a c h in e
a s c h in e
w a s c h m
positioning the hole indicated by the arrow in Fig. 9 towards
rta
La to po the inside of the face and using the type C screws.
e
Do or sid
rte
Co te po
Tu r se ite
·
F using the two type B screws.
12
N° 2 Hinge Supports
Fig. 9
N° 1 Magnet
Fig. 11
N° 1 Rubber plug
Fig. 13
Mount the hinge supports onto the face of the machine,
Mount the magnetic plate on the opposite side, at the top,
(Fig. 9-10-11-12-13-14)
N° 2 Hinges
Fig. 10
N° 1 Magnet plate
Fig. 12
N° 2 Base molding
guide
Fig. 14