Advertisement
2-4
2.4 EQUIPMENT/SOFTWARE STARTUP
When the Wave Designer software installation is complete, Wave Designer is listed among the
programs you can start up from the Windows startup screen. Click on START, point to the
programs option, then click on the Wave Designer option. The Wave Designer Welcome
screen is displayed followed by the Pulse Waveform Editor screen. When the Pulse Waveform
Editor screen is displayed, the software is ready for use.
File
Tools
Pulse Waveform Editor
Wire Feed Speed
Ramp Up Rate
Ramp Overshoot %
Peak Amps
Peak Time ms
Tailout Time
Tailout Speed
Stepoff Amps
Backgrd Amps
Backgrd Time
Frequency
Start
Status
2.5 UPGRADE FIRMWARE
An ArcScope application is provided with Wave Designer Pro. In order to run the ArcScope
application, it may be necessary to upgrade the welding machine firmware. If the old firmware
does not support ArcScope, the ArcScope application will display garbled data rather than
waveforms. Wave Designer will automatically detect the firmware version and prompt you to
upgrade the firmware if required.
SOFTWARE INSTALLATION
Wave Designer Pro Off Line - pulse.swf
Print
Help
700
600
Edit
50
500
600
-20
400
250
300
1.2
200
3.0
100
.100
0
0
40
21
33.4
26.4
Adapt
Short
End
About
AC.sco loaded
WAVE DESIGNER
3
6
9
12
15
Off Line
Stand by
Section 2
18
21
24
27
30
Adaptive
27850001
Advertisement
