Rear Panel Connections, Connecting Up Your Digital Receiver - Icecrypt T2300HD User Manual

Rear panel connections
The T2300 HD has the following connections on the back:
Connecting up your digital receiver
For power connection, always follow the LIFO rule: Last in First out!
Always disconnect the unit from the mains power socket before connecting or
disconnecting anything else (apart from USB hot plug devices)
PLEASE NOTE: This receiver has an Eco Low Power Saving function (under 1 Watt in
Standby). When this is turned ON the RF loop out will not be active and will not pass a TV
signal when the unit is in Standby. If you require the RF loop out to be active and pass a TV
signal while in Standby mode please keep the Eco Low Power Save function set to OFF.
This digital receiver can be used with most television sets on the market, except perhaps
the very old types without AV inputs of any kind. In most cases the digital receiver will work
with most televisions and other devices by using the correct kind of cable (HDMI, SCART to
SCART, SCART to RCA cables etc.).
Where possible, use HDMI connections for best results. However, if you are unsure the
type of cable you require for you TV set or AV devices, please contact your dealer.
Connect the terrestrial aerial to this socket
Terrestrial signal loop output socket: Connect other digital
receiver products to this socket.
Digital audio output socket for the audio-video receiver
Local area network (connect to your router)
USB device socket
Audio and video output socket for the high definition
television set
Audio and video output socket for the older television set
12V DC power inlet socket
Quick Start Guide