Lincoln Electric UWW-170 Operator's Manual page 38

D-5
GUN HANDLE PARTS (black trigger)
The gun handle consists of two halves that are held
together with a C-clip (located at the cable end of the
gun). To open up the gun handle assembly, remove
the C-clip and pry down the trigger handle half with a
screwdriver. See Figure D.3.
C-clip
FIGURE D.3
MAINTENANCE
Screwdriver
Cable
GUN HANDLE PARTS (red trigger)
The gun handle consists of two halves that are held
together with a collar on each end. To open up the
handle, turn the collars approximately 60 degrees
counter-clockwise until the collar reaches a stop. Then
pull the collar off the gun handle. If the collars are diffi-
cult to turn, position the gun handle against a corner,
place a screwdriver against the tab on the collar and
give the screwdriver a sharp blow to turn the collar
past an internal locking rib. See Figure D-4.
SP 170-I
Counter-clockwise
FIGURE D.4
D-5