Table of Contents
Advertisement
A-10
I / O RECEPTACLE SPECIFICATIONS
TABLE A.2
WIRE FEEDER RECEPTACLE
PIN
LEAD#
A
53
B
54
C
67A
D
52
E
51
TABLE A.3
VOLTAGE SENSE RECEPTACLE
PIN
LEAD#
3
21A
TABLE A.4
RS232 RECEPTACLE
PIN
LEAD#
2
253
3
254
4
#
5
#
6
# #
20
# #
7
251
DIP SWITCH SETTINGS AND LOCATIONS
DIP switches on the P.C. Boards allow for custom configuration of
the Power Wave. To access the DIP switches:
WARNING
ELECTRIC SHOCK can kill.
1. Turn off power to the power source at the dis-
connect switch.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
------------------------------------------------------------------------------------------
2. Remove the wrap around cover from the power source.
3. The control board is on the center assembly facing the case front.
Locate the 8-position DIP switch and look for switch 8 of the DIP
switch.
4. Using a pencil or other small object, slide the switch to the OFF
position if the work sense lead is NOT connected. Conversely, slide
the switch to the ON position if the work sense lead is present.
5. Replace the wrap around and screws. The PC board will "read" the
switch at power up, and configure the work voltage sense lead
appropriately.
CONTROL BOARD DIP SWITCH:
switch 1 = reserved for future use
switch 2 = reserved for future use
switch 3 = equipment group 1 selcted (default=off)
switch 4 = equipment group 2 selcted (default=off)
switch 5 = reserved for future use
switch 6 = reserved for future use
switch 7 = auto mapping
switch 8 = work sense lead
(See Figure A.8 for Dual Head Boom Feeder)
INSTALLATION
FUNCTION
Communication Bus L
Communication Bus H
Electrode Voltage Sense
0vdc
-
}
40VDC
+40vdc +
FUNCTION
Work Voltage Sense
FUNCTION
RS232 Receive
RS232 Transmit
Pin5
Pin4
Pin20
Pin6
RS232 Common
POWER WAVE 355M
switch 7
auto mapping
off
auto mapping enable-default
on
auto mapping disabled
switch 8*
work sense lead
off
work sense lead not connected
on
work sense lead connected
*Factory setting for Switch 8 is OFF.
FIGURE A.7
CONTROL BOARD (DIP Switch Location)
FIGURE A.8
A-10
Advertisement
Table of Contents
