Desa (V)T32N series Owner's Operation And Installation Manual page 24

Direct-vent "tudor" models
Table of Contents

Advertisement

FIREPLACE
INSTALLATION
Continued
REMOVING/REPLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa-
tion see Replacement Parts,
page 36.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before re-
moving glass door or louvers.
Removing Louver Panels
Remove the top and bottom louver panels by
simultaneously pulling both top end spring
latches towards the center of the appliance
until they are disengaged from the locating
holes (see Figure 40). Repeat for bottom
spring latches and pull the louvers outward.
To install or replace items removed, simply
reverse the procedures above.
Figure 40 - Removing Louver Panel
24
Spring
Latch
Louver Panel
www.desatech.com
Removing Glass Door
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced.
If glass is broken, wear gloves and tape the
remaining fragments onto the frame.
1. Remove screen assembly by pushing the
rod either left or right and then down and
forward to remove screen/rod assembly
from the firebox. Set assembly aside.
2. Lift up on latches to unlock. There are two
on top of firebox and two below firebox that
hold glass door in place (see Figure 41).
3. While holding glass door to prevent it from
falling and causing injury, remove the five
screws from the hinge located on the left side
of door frame assembly (see Figure 41).
4. Remount the new frame at the hinge with
five new screws before closing door. This
will ensure seating of the gasket.
5. Close glass door frame. Lock latches by
placing the bar under the tab on door and
pushing down and back on latch (see
Figure 41).
6. Replace screen/rod assembly by revers-
ing step 1.
7. Replace louvers by reversing procedure
under Removing Louver Panels.
Unlock
Lock
Screw
Hinge
Glass
Frame
Assembly
Figure 41 - Removing/Replacing Glass
Cleaning Glass Door
See Cleaning and Maintenance on page 30.
Latch
Door
111986-01F

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents