Advertisement
Information You Should Know Before
Operating the IR Ear Thermometer
Why / How to use IR forehead
thermometer correctly?
1.It is useful to try this thermometer on
yourself first to be familiar with it.
2.The thermometer should be in the
room where measurement will be
taken 20-30 minutes prior to
measurement. The person whose
temperature is being taken should be
in the same room at least 20 minutes
before the measurement.
3.Keep the forehead clean from sweat,
make-up, etc.
4.Avoid taking measurement for 30
minutes after physical exercise,
bathing or eating.
5.Body temperature, like blood
pressure, varies from person to
person, and during the day, it may
range from 35.5°C to 37.8°C (95.9°F
to 100.0°F). The forehead
temperature is converted by the
thermometer to the commonly used
oral temperature. For some people it
may show some difference from their
normal oral temperature. It is
recommended to learn and
recognize the forehead temperature
while healthy. For accurate results,
measure the same area on the
forehead each time a temperature is
Taken.
4
Preparation for Use
Installing/Replacing the Battery
1. Pull the battery cover off in the
direction shown.
2. Install two new "AAA" batteries into
the battery compartment matching
correct polarities.
3.Replace and fasten the battery cover
securely.
Warning:
Do not put used batteries in trash .
Recycle or manage as hazardous waste.
Never dispose of batteries in fire.
Dispose in recycling trash only. Do not
recharge, put in backwards or
disassemble. This may cause explosion,
leakage and injury.
Caution:
When replacing batteries, do not mix old
ones an new ones. Do not mix alkaline,
standard(carbon-zinc) or
rechargeable(nickel-cadmium) batteries.
1
2
3
5
How to Operate the Thermometer
1. Press and release the On/Off button
to turn on the unit.
The display will
A
show the last memory(Figure1) .
beep is heard. After about 2
seconds, the display shows that the
unit is ready for measurement.
(Figure2)
2. Place the probe into the ear canal
then press and release the On/Off
button to start measurement. (You
will hear a beep.)
3. While it is measuring, the display
will show as
(Figure3).
4. A "beep-beep"sound is heard when
the measurement is completed.
(Figure4)
5. If the temperature reading is above
38°C, eight consecutive beeps will
be heard to indicate fever alarm.
6. Wait the hourglass disappear, the
display will show the ready for
measurement
, now you
(Figure2)
can start a new measurement by
press On/Off button again.
Forehead mode
7. Press the M botton for 2 seconds, it
will switch from "Ear" mode to
"Forehead" mode
. You
(Figure5)
need to apply the probe attachment.
8. Place the probe attachment on the
probe of the thermometer then place
it on the middle of the forehead.
Ensure proper contact between
forehead and probe.
6
How to Operate the Thermometer
9. Press the On/Off button to start
measurement with moving
the probe
across the left or right side of the
forehead to the temporal artery for at
least three seconds(Figure6),during
the measurement the display shows
as (Figure 7) then release the On/Off
.
button
10. You will hear a "beep-beep"sound
with the measuring value showed
as
(Figure8)
11. Turn off the unit :It will auto power
off in 1 minute.
(Figure1)
(Figure2)
(Figure3)
(Figure4)
(Figure5)
(Figure6) (Figure7)
(Figure8)
7
Advertisement
