Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for LINOVISION IPC-V3020-IW
- Page 1 HD Mini IR Waterproof Fixed Network Camera Quick Start Guide Version 1.0.0...
- Page 2 Welcome Thank you for purchasing our Network camera! This user’s manual is designed to be a reference tool for your system. Please read the following safeguard and warnings carefully before you use this series product! Please keep this user’s manual well for future reference! Important Safeguards and Warnings 1．Electrical safety All installation and operation here should conform to your local electrical safety codes.
- Page 3 Please do not dismantle the device; there is no component which can be fixed by users themselves in the machine. It may cause water leakage or bad image for the device due to unprofessional dismantling. It is recommended to use the device with thunder proof device in order to improve thunder proof effect. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
- Page 4 Please refer to the disk for more details, check and download corresponding user’s manual and tool. Before installation, please open the package and check all the components are included. Contact your local retailer ASAP if something is broken in your package. Accessory Name Amount Network Camera Unit...
-
Page 5: Table Of Contents
Table of Contents Framework ........................... 1 Device External Cable ....................1 Framework and Dimension ..................2 Device Installation ........................4 Network Configuration ....................... 7 Modify IP Address ......................7 Login WEB Interface ....................8... -
Page 6: Framework
1 Framework 1.1 Device External Cable You can refer to the following figure for cable information. See Figure 1- Figure 1-1 Cable Figure 1-2 Cable Please refer to the following sheet for detailed information. Port Port name Connector Function description Connect to standard Ethernet cable. -
Page 7: Framework And Dimension
1.2 Framework and Dimension The following figures are for reference only, which are used to know the device dimension, please refer to the following figures according to the actual device. Figure 1-3 Figure 1-4... - Page 8 Figure 1-5...
-
Page 9: Device Installation
2 Device Installation Important Please make sure the installation surface can min support the 3X weight of the camera and the bracket. Figure 2-1 Device installation 1 Please see Figure 2-1 and Figure 2-2. Step 1 Stick installation map to designated surface where you will install the device (wall or ceiling). Step 2 Dig a hole according to position of hole on installation map. -
Page 10: Step
Figure 2-2 Device installation 2 Step 6 Use cross head screw-driver (in accessories bag) to loosen adjusting screw. Step 7 Adjust the device in all possible directions, and set its monitoring direction according to the requirements. Step 8 Use cross head screw-driver to tighten the adjusting screws. Figure 2-3... -
Page 11: Step
Step 9 First rotate the bracket to one side, and then aim the end of thread of WIFI antenna in the accessories bag at the copper nut on the bottom of the back cylinder. Figure 2-4 Step 10 Then bend the antenna in the way shown in Figure 2-4, move the bracket back to the original location. -
Page 12: Network Configuration
3 Network Configuration The IP address of all the cameras is the same when leaving factory (default IP192.168.1.108), in order to make the camera get access to the network smoothly, please plan the useable IP segment reasonably according to the actual network environment. 3.1 Modify IP Address IP address can be acquired and modified through quick configuration tool for the cameras which are accessed via wired network, it needs to connect wired network to configure wireless... -
Page 13: Login Web Interface
Figure 3-1 Step 3 Modify the camera IP address on the “Net” interface, click “Save” to finish modification. See Figure 3-2 for more details. Figure 3-2 3.2 Login WEB Interface Note: Different devices may have different WEB interfaces, the figures below are just for reference, please refer to the document <<WEB Operation Manual>>... - Page 14 Figure 3-3 Step 3 Install controls according to the system prompt; see Figure 3-4 for the WEB main interface. Please modify the administrator password as soon as possible after you successfully logged in. Figure 3-4...
- Page 15 Note: This quick start guide is for reference only. Slight difference may be found in user interface. All the designs and software here are subject to change without prior written notice. If there is any uncertainty or controversy, please refer to the final explanation of us. ...