Marvin 5060 Instruction Manual

FOR REPAIRS
THREE-YEAR
LIMITED WARRANTY
Do not attempt to service or repair this
heater. If damaged or not functioning
2-YEAR WARRANTY ON HEATING ELEMENTS
properly, return heater to W.B. Marvin.
For safety reasons, servicing is only
W.B.Marvin Manufacturing Co., the
available at the factory. Parts can
manufacturer, warrants to original
not be sent to the customer.
purchasers of their electric heaters that
Marvin heaters shall be free from
When returning the heater to us, pack the
electrical defects for a period of three (3)
heater in its original carton THEN pack that
years (2 years for heating elements) from
box in a larger shipping box and pad well.
the provable date of purchase. The
applicability of any implied warranties is
Ship to:
limited to the same three (3) year (2 years
W.B. Marvin Manufacturing Co.
for heating elements) period. Some states
Inspection Department
do not allow limitations on how long an
211 Glenn Avenue
implied warranty lasts, so the above
Urbana, Ohio 43078-0230
limitations may not apply to you. The
For Warranty Repairs manufacturer is not responsible for any
defect or malfunction caused by abuse or
Include proof of purchase and a note
misuse occurring while the heater is in the
explaining the problem with your heater,
possession of the purchaser including
and a return address.
without limitation uses for purposes not
We'll repair or replace (at our option) your
intended by the manufacturer.
heater and return it. Please allow 2 weeks.
The manufacturer is not responsible for
For Out-of-Warranty Repairs
any defect or malfunction caused by
Return heater along with a note explaining
repairs attempted by others, damage in
the problem with your heater, a phone
transit, abusive treatment or commercial
number where you can be reached during
application.
the day, and a return address.
In the event of the occurrence of a defect
We will inspect your heater & call you
covered by this warranty, the original
with a quote for the cost of repairs.
purchaser shall, at his expense, return the
heater along with proof of purchase to the
W.B. Marvin is concerned about
manufacturer, attention Inspection
the well being of our
Department. If the defect is covered by
environment, and we'd like to
this warranty, the manufacturer shall
point out the following:
within sixty (60) days after receipt thereof
correct the electrical defect without cost to
1. Many components of our products are
the original purchaser. Any questions
made from recyclable materials.
concerning this warranty shall by directed
And, we will continue to look for new
to the Inspection Department of the
materials to help the environment.
manufacturer.
2. The use of our heaters encourages
This warranty gives you specific legal
conservation by allowing the user to
conserve on central heating. rights, and you also may have other rights
which vary from state to state.
3. All shipping cartons are recyclable.
W.B. Marvin is constantly looking for
The W.B.Marvin
new ways to help the environment.
Manufacturing Company
Please don't hesitate to send us your
suggestions.
8
QUARTZ HEATER
WITH STEAM HUMIDIFIER
AND FRAGRANCE TRAY
With Replaceable Elements
INSTRUCTION MANUAL
WARRANTY INFORMATION
W.B. Marvin Manufacturing Company
UNDERWRITERS
LABORATORIES 211 Glenn Avenue,
LISTED
Urbana, Ohio 43078-0230
937-653-7131, Fax 937-652-1375
Made in the U.S.A.
Toll-Free: 1-800-733-1706
005060-0700 www.wbmarvin.com
MODEL 5060
Congratulations!
On becoming a new Marvin
manufactures a complete line of high quality, safe, electric
heaters designed to provide years of trouble free service.
Our heaters are made right here in Urbana, Ohio.
Many of our employees are second or third generation,
and all of them are dedicated to giving you the finest heaters
in the world.
We want you to be pleased and satisfied with your new
Marvin Heater. All of our heaters are tested at the factory
before shipping to insure quality.
Should you have any problem with this product, please call
our Customer Service Department toll-free at 1-800-733-1706.
Your call will receive prompt and courteous attention.
Pass on the good news to your friends. Marvin Heaters are
the best choice for quality, efficiency and safety features, and
they are made in the U.S.A.
We appreciate your comments about our products and
look forward to hearing from you. Thanks again for
choosing Marvin.
Sincerely,
Angus Randolph, President
W.B. Marvin Manufacturing Company
HUMIDIFIER CLEANING
1. The humidifier tank should be
cleaned once a week when used
continuously. For best results in hard
water areas use distilled water in the
water tank.
2. Drain all remaining water from tank
through the drain hole on the side of the
heater.
3. Add new water and thoroughly rinse
the tank, then drain at once.
4. Refill only when unit is going to be
used.
PLEASE READ AND SAVE THESE
SINCE 1915
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
Heater owner. Marvin
® 1. Read all instructions before using
this heater.
2. This heater is hot when in use. To
avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when
moving this heater. Keep combustible
materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at
least 3 feet (0.9m) from the front of the
heater and keep them away from the sides
and rear.
3. Extreme caution is necessary when
any heater is used by or near children or
invalids and whenever the heater is left
operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a
damaged cord or plug or after the heater
malfunctions, has been dropped or
damaged in any manner. Return heater to
W.B. Marvin Manufacturing Co. for
examination, electrical or mechanical
adjustment, or repair. (See the section "For
Repairs" on the back cover)
6. Do not use outdoors.
7. This heater is not intended for use in
bathrooms, laundry areas and similar
indoor locations. Never locate heater
where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do
5. If the humidifier sputters and emits
not cover cord with throw rugs, runners, or
water droplets from the filler port, mineral
the like. Arrange cord away from traffic
solids have begun to clog the system.
This can be relieved by adding vinegar to
the rinse water.
A mixture of one tablespoon of vinegar to
one quart of water will disolve most
mineral build-up. Allow the vinegar water
to "work" for a few minutes before
draining.
6. Rinse the tank with plain water after
cleaning with vinegar.
2
area and where it will not be tripped over.
9. To disconnect heater, turn controls to
off, then remove plug from outlet.
10. Connect to properly grounded
outlet only.
11. Do not insert or allow foreign objects
to enter any ventilation or exhaust opening
as this may cause an electric shock or fire,
or damage the heater.
12. To prevent a possible fire, do not
block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed,
where openings may become blocked.
13. A heater has hot and arcing or
sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable
liquids are used or stored.
14. Use this heater only as described in
this manual. Any other use not
recommended by the manufacturer may
cause fire, electric shock, or injury to
persons.
15. Avoid the use of an extension cord
because the extension cord may overheat
and cause a risk of fire. However, if you
have to use an extension cord, the cord
shall be No. 14 AWG minimum size and
rated not less than 1875 watts.
16. This heater includes a visual alarm to
warn that parts of the heater are getting
excessively hot. If the red overheat light
comes on, immediately turn the heater off
and inspect for any objects on or adjacent
to the heater that may cause high
temperatures. Do not operate the
heater with the overheat light on.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED A.C.
(Altnernating Current) PLUG (a plug having one blade
wider than the other). This plug will fit into the power
outlet only one way. Match wide blade of plug to wide
slot. This is a safety feature. If you are unable to insert
the plug fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact an electrician to
replace the obsolete outlet. DO NOT DEFEAT THE
PURPOSE OF THIS POLARIZED PLUG.