Sony KP-57WV600 Service Manual page 334

General
Problem
How to reset TV to
factory settings
How to restore Video settings
to factory settings
How to restore Audio
settings to factory settings
Cannot cycle through the
other video equipment
connected to the TV
Cannot operate Menu
Lost password
LED on front panel is lit
94
Possible Remedies
❏
Turn on the TV. While holding down the
control, press the POWER
back on again.) Release the
❏
RESET
Press the button on the remote control while in the Video Menu (see
page 72).
❏
Press the RESET button on the remote control while in the Audio Menu (see
page 74).
❏
Be sure the Video Label
❏
If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.
❏
In the password screen (see page 80), enter the following master password:
4357. The master password clears your previous password; it cannot be
used to temporarily unblock channels.
❏
The STAND BY LED (see page 14) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
❏
The TIMER LED (see page 14) indicates that the timer is set. When the
timer is set, this LED will remain lit even when the TV is turned off.
RESET
button on the TV. (The TV will turn itself off, then
RESET button.
option is not set to Skip (see page 84).
button on the remote