HOLOPHANE Predator Small Floodlight Marine Installation And Maintenance Manual

AFTER INSTALLATION DELIVER THIS
MANUAL TO OWNER

IMPORTANT SAFETY INSTRUCTIONS

WARNING
-READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO INSTALL OR
MAINTAIN THIS FIXTURE.
BY QUALIFIED PERSONNEL.
WARNING
-BE CERTAIN THAT ALL ELECTRICAL
POWER IS DISCONNECTED FROM THE FIXTURE
BEFORE INSTALLING OR MAINTAINING THE FIXTURE.
WARNING
-FOLLOW LAMP MANUFACTURER'S
OPERATING AND MAINTENANCE INSTRUCTIONS.
FAILURE TO FOLLOW THESE WARNINGS MAY
RESULT IN DEATH, INJURY OR SIGNIFICANT
PROPERTY DAMAGE.

1. INTRODUCTION

1.1 Product Description.

designed and tested in accordance with UL844 and UL595. These
floodlights comply with applicable paragraphs of Sections 501, 502,
and 503 of the National Electrical Code.
-The fixture identification label provides information regarding
suitable environmental applications.
-The floodlight model size is referred to in Figure 1.
-Major components of the floodlight are identified in Figure 1.
-The Predator floodlights have been designed to allow permanent
installation of the yoke or box mount and housing while still
providing easy maintenance and repair.
-The lamp, all electrical components, and the reflector can be
accessed by opening the door.
-Using a socket wrench, the door can be opened by loosening
captive door screws.
Predator
Small Floodlight Marine
WORK MUST BE DONE
The Predator floodlights have been
®
-All electrical components and the lens are contained on the door
and the door can be removed easily and without tools (once the
captive door screws are loosened).
-Doors can be replaced as units and repaired in a shop under
protected conditions.
-The reflector located within the housing can be replaced as
needed. Different types of reflectors will provide different light
distributions.

1.2 Alternate Information Sources.

questions arise relative to the Predator floodlight that this document
or your supplier cannot answer please refer them to:

2. INSTALLATION

2.1 Tools and Materials Required.

and materials are required during installation of the Predator
floodlight.
TABLE 1. Installation Tools and Materials
DESCRIPTION
3/8" hex head socket wrench
3/4" hex head wrench
1/2" hex head socket wrench
Pliers
Torque wrench
Wire nuts

2.2 Yoke Mount Installation.

DO NOT USE A PHOTOCONTROL IN A LOCATION
HAVING A UL CLASSIFICATION OF CLASS I, DIV. 2
OR CLASS II, DIV. 1.
LOCATION HAVING A UL CLASSIFICATION OF
GR421
CLASS I. FAILURE TO FOLLOW THESE WARNING
INSTRUCTIONS MAY RESULT IN FIRE AND
SIGNIFICANT PROPERTY DAMAGE.
2.2.1
Bolt the yoke to the mounting structure through the provided
holes in the yoke using two 3/8" bolts (not provided).
2.2.2
Loosen the captive door screws attaching the door to the
housing. Open the door.
2.2.3
Detach the power disconnect plug from the disconnect
receptacle in the housing.
2.2.4
If needed, remove the door by removing the cotter pin from
the hinge pin and sliding the door hinge pins out of the housing.
2.2.5
Use UL approved watertight power cord fittings (not
provided) on all installations. If installed in a Marine location, use
rigid metal conduit or AVC Marine cable (not provided) and water-
tight cable grip fittings (not provided) for power supply conductors.
Installation and
Maintenance
Manual
If additional
Holophane
Field Service Department
P.O. Box 3004
Newark, OH 43058-3004
866-759-1577
The following tools
USE
Captive door screws
Yoke bolt
Box Mount
Cord grip (if applicable)
Captive door screws and bolts
(inch and foot lbs.)
WARNING
DO NOT USE FUSING IN A
IM-60-C