About this document: All rights reserved. This document contains information that is proprietary to TANDBERG. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically, mechanically, by photocopying, or otherwise, without the prior written permission of TANDBERG.
FieldView External Charger User Manual D14059.02 April 2007 Introduction The external charger from TANDBERG is a battery charger and conditioning station. The external charger provides a conditioning cycle which ensures that the reported energy from the smart battery (116314) will match its actual energy thereby maximizing battery efficiency.
Smart Battery State versus Actual State The smart battery (P/N 116314) reports its remaining available energy to the FieldView Device. In some extreme cases the internal reported available energy of the smart battery can become out of sync with the actual available energy.
TANDBERG FieldView External Charger User Manual D14059.02 April 2007 Figure 2 Condition Button Upon the start of conditioning, the Mode LED will turn solid ORANGE and the Status LED will be RED. The battery should not be removed until conditioning has completed. Conditioning ends when both the Mode and Status LED’s are green.
TANDBERG FieldView External Charger User Manual D14059.02 April 2007 Storing the External Charger • Remove the battery before disconnecting the adapter from the unit. • Always disconnect the charger from the AC adapter and the AC adapter from the AC by pulling on the plug and not on the cord.
Page 8
E-mail: tandberg@tandberg.com Support (North America only): +1 866 826 3237...