Toro Groundsmaster 4700-D Service Manual page 31

7. Position upper radiator shroud to the radiator. Secu-
re shroud to the radiator and lower radiator bracket with
removed fasteners (see Radiator Installation in this sec-
tion). Make sure that clearance between shroud and fan
is at least 0.180" (4.6 mm) at all points.
8. Connect throttle cable to the speed control lever with
washer and lock nut. Install cable to mounting bracket.
Adjust throttle cable.
9. Connect throttle cable to engine (Fig. 11):
A. Secure throttle cable swivel to speed control le-
ver with lock nut.
B. Place throttle cable under cable clamp.
C. Adjust throttle cable position in cable clamp so
that engine governor lever contacts the high speed
stop bolt at the same time that the throttle lever con-
tacts the end of the slot in the control console.
D. Tighten cable clamp to secure throttle cable.
10.Remove caps from fuel hose and injector pump fuel
inlet that were placed during engine removal to prevent
contamination. Connect fuel supply hose to injection
pump (Fig. 11).
11. Connect wire harness connectors to the following
engine components:
A. The engine run solenoid (Fig. 11).
B. The temperature sender (Fig. 12).
C. The alternator (Fig. 12).
D. The glow plug connection.
E. Wire harness connector to engine ground har-
ness.
F. The electric starter. Torque nut at starter B+ termi-
nal from 70 to 86 in- -lb (7.9 to 9.7 N- -m).
G. Low oil pressure switch located on alternator side
of engine (above electric starter).
Groundsmaster 4500--D/4700--D
12.Using notes taken during engine removal, secure
wires with cable ties in proper locations.
13.Install air cleaner assembly to the engine (see Air
Cleaner Installation in this section).
14.Install exhaust system to machine (see Muffler
Installation in this section).
15.Connect coolant hoses to the radiator. Make sure ra-
diator draincock is closed. Fill radiator and reservoir with
coolant.
16.Check position of wires, fuel lines, hydraulic hoses
and cables for proper clearance with rotating, high tem-
perature and moving components.
17.Connect positive battery cable first and then nega-
tive battery cable. Secure battery cover to machine.
18.Check and adjust engine oil level as needed.
19.Check and adjust hydraulic oil level as needed.
20.Bleed fuel system.
21.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in the Service
and Repairs section of Chapter 4 -- Hydraulic Systems).
22.Install hood on the machine (see Hood Installation in
the Service and Repairs section of Chapter 7 -- Chas-
sis).
Page 3 - - 15 Kubota Diesel Engine