Advertisement
a) Go to the Tools menu and click Setup.
b) Click on the Network tab at the top and you will see a list under Web User Settings.
c) Enter a User Name and Password in to the respected fields and then choose the User Rights.
d) Click Add User once all fields have been completed. Click Delete to remove a User.
Updating Your HomeTroller S6 and Setting the Time Zone
Be sure to check for updates and install any that are available and set the time zone. To do this, follow these steps:
a) Upon HomeSeer booting it will check for updates.
b) You can either restart your HomeTroller or just restart HS3.
c) HomeSeer needs to be shut down once the update procedure begins.
a) Double click on the time in the bottom right of your screen in the system tray and then click Change Time Zone.
STEP #2
– Local and Remote Access
Welcome to the new MyHomeSeer Remote. MyHS will allow you to access your HS3
system from anywhere without having to touch your router. There are requires for
To begin using MyHSRemote you will need to register your HS3 software with the
connected service.
Registration
a) Once the HSTouch has finished installing, go ahead and open it up. You will
be prompted with a Log In to MyHS screen.
b) Click Register. Your default browser will come forward and load the
registration page.
c) Enter in the preferred email address you would like to use to be tied
to your MyHS for the Account Email Address. This will later be used
as your MyHS username.
d) Enter a preferred Account Password. You will use this as the
password to enter in your MyHS settings.
e) The License ID you are asked for is your HS3 licenseID. The same
goes for your License Password. (For HomeTroller HS3 users, this is
located on the bottom of your unit. For HS3 Software users, this
information was emailed to you.)
f) Click Register. You will receive a confirmation on the next screen
unless errors are detected. You will also be emailed an email that
MyHS to work. HS3 must be version 3.0.0.97
or later. HSTouch Android client requires
1.0.0.76 or later. Please make sure to update
to these versions. It is recommended that you
uninstall the application and then reinstall it
from the Play Store/iTunes Store. (This guide
assumes you have HSTouch Server already set
up. If you do not, please refer to the HS3 Quick
Start Guide on setting that up). Now, let's get
started!
Page 2
Advertisement
