Advertisement
Your fireplace's remote control helps you get the comfort, convenience and aesthetics you want from your ap-
pliance. The "remote" controls your fireplace in different ways.
Note: If you would just like to turn your fireplace to the desired temperature, just press the SET button to ☼
or ☽
and press and hold the SET button until the display flashes; press the ▲(up) or ▼(down) buttons to
temp
the desired temperature.
Operation
MAN MODE—Manual Mode. The flame height can be
man
Modes
adjusted in the following manners:
1.
Press the ▲(up) button to turn on the main burner.
2.
Press the ▲(up) button to increase the flame height.
3.
Press the ▼(down) button to decrease the flame height
or to go to pilot Standby position.
For fine adjustments, tap the ▲ and ▼ buttons.
NOTE: While pressing either button, a symbol indicating
transmission appears on the upper right hand corner of the
display. The receiver confirms transmission with an acoustic
signal
STANDBY MODE—Ignited pilot only.
☼
temp
(appliance must be in standby mode; pilot ignited): The
room temperature is measured and compared to the set
Temperature. The flame height is then automatically adjusted
to achieve the Daytime set temperature.
☽
temp
mode, pilot ignited): The room temperature is measured and compared to the Nighttime
Setback temperature. The flame height is then automatically adjusted to achieve the
Nighttime Setback temperature.
allows you to set two (2) burner ON times and two (2) burner OFF times for every 24-hour
period.
Changing the Mode of Operation
Briefly pressing the SET button changes the mode of operation in the following order:
→
man
NOTE: MAN mode can also be reached by pressing either the ▲or the ▼buttons.
In TEMP mode,
☼ indicates the daytime temperature setting.
☽ indicates the nighttime temperature setting.
In TIMER mode,
☼ indicates the start time setting.
☽ indicates the stop time setting.
GV60 Programmable Remote Control
TEMP MODE—Daytime Temperature Mode
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby
TimeR MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting
→
→
☼
☽
temp
temp
→
and back to
timer
man
.
temp
Advertisement
Table of Contents
Related Manuals for Miles Industries GV60
Summary of Contents for Miles Industries GV60
- Page 1 GV60 Programmable Remote Control Your fireplace’s remote control helps you get the comfort, convenience and aesthetics you want from your ap- pliance. The “remote” controls your fireplace in different ways. Note: If you would just like to turn your fireplace to the desired temperature, just press the SET button to ☼...
- Page 2 Time To set the time, follow the steps below. The display indicates °C/24-hour or °F/12-hour clock. To change from one to the other, press and hold both the OFF and ▼buttons until the display changes. Hold down both the ▲and the ▼buttons until the display flashes. Let Quickly press the ▲to set the hour and the ▼to set the minutes.
- Page 3 Timer It is possible to program two periods of time per day at which your fire- place will turn on and off automatically. For exemple, you can set your fireplace to turn on in the morning just be- fore you get up (P1 ☼ [start time]) and to turn off when you leave for the day (P1 ☽...
Need help?
Do you have a question about the GV60 and is the answer not in the manual?
Questions and answers