Miles Industries GV60 Operation

Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace.
The remote controls your fireplace in different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic
ON/OFF can only be programmed when the function display is flashing. Be patient when programming as it can take
a few seconds to set.

Operation Modes

MAN MODE­—Manual Mode. The flame height can be adjusted in the following
man
manners:
. Press the ▲ (up) button to turn on the main burner.
2. Press the ▲ (up) button to increase the flame height.
. Press the ▼ (down) button to decrease the flame height or to go to pilot Standby
position.
For fine adjustments, tap the ▲ and ▼ buttons.
NOTE: While pressing either button, a symbol indicating transmission appears on the
upper right hand corner of the display. The receiver confirms transmission with an
acoustic signal.
STANDBY MODE—Ignited pilot only.
☼
TEMP MODE—Daytime Temperature Mode (appliance must be in Standby
temp
mode; pilot ignited): The room temperature is measured and compared to the set
Temperature. The flame height is then automatically adjusted to achieve the Daytime
set temperature.
☽
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be
temp
in Standby mode, pilot ignited): The room temperature is measured and compared to the
Nighttime Setback temperature. The flame height is then automatically adjusted to achieve the
Nighttime Setback temperature.
Timer MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting
Timer
allows you to set two burner ON times and two burner OFF times for every 24-hour period.

Changing the Mode of Operation

Briefly pressing the SET button changes the mode of operation in the following order:
→ →
☼ ☽
man temp temp
NOTE: MAN mode can also be reached by pressing either the ▲ or ▼ buttons.
In TEMP mode,
☼ indicates the daytime temperature setting.
☽ indicates the nighttime temperature setting.
In TIMER mode,
☼ indicates the start time setting.
☽ indicates the stop time setting.
GV60 Remote Control Operation
→ →
and back to
timer
.
man