Advertisement
(2) Place the staple strip over the magazine.
Make sure that the staple strip slides freely on the
magazine. (See Fig. 3)
Staple
(3) Pull the staple feeder backward. Then, detach it from
the groove of magazine and softly bring the staple
back as if it were being gently pushed, avoiding any
impact. (See Fig. 4)
The stapler is now ready to operate.
CAUTIONS:
If the staple feeder is released all of a sudden, it can
return abruptly, causing deformation and/or scatter,
eventually ending up in clogged staples.
Be absolutely sure to bring back the staple feeder,
avoiding any impact.
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a
work bench on floor. Also, never face the staple outlet
toward any part of a person.
HOW TO USE THE STAPLER
CAUTIONS:
Never use the head or body of this device as a
hammer.
Take precautions to ensure the safety of persons in
the vicinity during operation.
1. Stapling procedures
(1) Intermittent stapling
Depress the staple outlet onto the desired point; then
pull the trigger to drive a staple in a single shot. (See
Fig. 5)
5
Magazine
Fig. 3
Staple Feeder
Fig. 4
CAUTION:
This tool will bounce and shoot several staples instead
of just one in rapid succession when strongly pressed
flush against a surface or when using on hard
materials. In such cases, fire the staples by squeezing
and quickly releasing the trigger.
(2) Push lever
When depressing the staple outlet, be sure to fully lift
the push lever (See Fig. 5) to release the safety lock.
Thus, staples cannot be driven without releasing the
safety lock even though the trigger is pulled.
Push Lever
(3) Continuous stapling
First, pull the trigger. Then depress the devise onto
the desired position to automatically drive staples.
(See Fig. 6).
Previously pull the trigger
Push Lever
CAUTIONS:
Exercise care when stapling corners of lumber. When
continuous stapling corners of lumber, a staple may
go astray or break through the corner.
Do not drive a staple on another staple.
Do not drive a staple on metal parts.
NOTES:
Precautions on no-load operation
Sometimes stapling will continue after driving in all
staples previously contained in the magazine.
This is termed "no-load operation". Such operation
may deteriorate the bumper, magazine, and staple
feeder.
To avoid no-load operation, occasionally confirm the
amount of remaining staples. On the other hand, all
staples should be removed after using this stapler.
Trigger
Fig. 5
Fig. 6
Advertisement
