System Operating Instructions; Cm800, Cm900 Annunciators; Sf117 Series, Sf118 Series Emergency Call Stations; Sf154 Emergency Call Station - TekTone CM800 Operation, Installation And Service Manual

System Operating Instructions ——————————————

CM800, CM900 Annunciators

SF117 series, SF118 series Emergency Call Stations

SF154 Emergency Call Station

Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
System operators must read the following operating instructions concerning system
equipment and terms used in conjunction with the equipment.
Answer Emergency Calls:
Emergency calls are indicated by simultaneous operation of the following signals:
• Steady illumination of the associated station selector lamp, which is marked to
indicate call origin.
• Rapidly pulsating audible tone. The audible call signal may be canceled by pressing
the tone-off button. The tone-off light will illuminate to indicate that tone is silenced.
The tone-off button may be pressed at any time to verify operation of the tone-off lamp.
Call signals may only be canceled at the point of origin, and all calls must be answered in
person.
Test Station Annunciator Lamp (if so equipped):
One lamp test button is provided on each panel of annunciator lamps. Press the lamp
test button—all annunciator lamps on that panel should be illuminated.
Improper Operation:
If the CM800 or CM900 Annunciator fails to operate as described, contact qualified
maintenance personnel. If a malfunction occurs during a call-in, causing a lack of
indication of call origin on the master station, first determine the origin of the call by
observing which corridor light is illuminated, and then inform qualified personnel.
Place an Emergency Call:
Pull the call cord and wait for an Attendant. (Note: The SF118 series station has a red call-
placed light that illuminates when the cord is pulled.)
Reset the Station:
Push the slide switch up.
Improper Operation:
If the station does not operate as described, contact qualified personnel. There are no
user serviceable parts on SF117 series and SF118 series Emergency Call Stations.
Place an Emergency Call:
Press the switch in so that the red area of the switch is visible, and wait for an Attendant.
Reset the Station:
Press the switch out so that the red area of the switch is not visible.
Improper Operation:
If the station does not operate as described, contact qualified personnel. There are no
user serviceable parts on the SF154 Emergency Call Station.
IL514 CM800/CM900 Emergency Call System Manual • 1