Samsung 8500 Quick Start Manual

Attach the TV to Connect video
the Stand devices
Step 1 Step
Warning: Screens can be damaged
from direct pressure when handled
incorrectly. We recommend lifting the
TV by the edges, as shown.
Step 1 Attach the TV to the Stand
1A
REQUIRED TOOLS: a Phillips head screwdriver and a soft, flat surface larger than the TV
(such as the box).
1C
R
L
1E
1G
x4 (M4 X L12)

QUICK START

GUIDE
BN68-05530A-02
Power on and
Using the Smart
start the initial
Touch Control
setup
2 Step 3 Step
Lay the TV on a soft surface, screen side down.
Use the packing material to protect the screen.
Fit the stand and mount together, making sure
the notch on the mount aligns with the stand.
Remove the protection film from the
bottom of the TV and stand, as shown by the
illustration.
Insert 2 screws and secure the stand to the TV.
Welcome to your new Smart TV!
The following instructions cover assembling, connecting, and setting up your new TV. Make
sure you have the accessories listed below.
Included in this box
Remote Control
Smart Touch Control
Batteries (AAA x 4)
4
Rubber packing
Remote Control
Also included:
User Manual, regulatory guide, 3D Active Glasses
1B
x 2
Base Leg
1D
x8 (M4 X L12)
1F
Warning: Handling the TV incorrectly can result
in injury. After setting the stand into the TV, we
recommend not lifting the TV using the stand. Lift
it by grabbing the front and bottom, as shown.
Stand Parts and Cables
Cable clip Power cord
RCA adapter Component adapter
Draw the base, legs, and screws out of the box
to put them together into the stand.
x 12
Screws
] Don't apply pressure to the base, as
illustrated by the figure.
Insert 4 screws and secure the stand to the TV.
Holding the stand parallel to the screen, slide
the stand into the notches on the back of the
TV.
Fit the guide protrusion on each edge of the
stand in the matching hole on the sole of the
TV.
Placing the TV on an uneven surface may cause the TV to shake.
✎
If placing the TV on an uneven surface, use the provided rubber
packing to secure the TV stand. See the figure below and attach
the provided rubber packing to the TV stand.
IR extender
Blanking Bracket
Rubber packing