Advertisement
Installation
Instructions —
Built-In Outdoor
Grill
(non-combustible
construction)
WARNING
Fire Hazard
Do not install this grill on or near
combustible materials.
Doing so can result in death or fire.
IMPORTANT: If grill is to be installed in a
combustible enclosure, return this unit
and replace it with the model which is
manufactured for use in a combustible
enclosure.
WARNING
Fire Hazard
Do not use grill near combustible
materials.
Do not store combustible materials
near grill.
Doing so can result in death or fire.
WARNING
Excessive Weight Hazard
Use two or more people to move
and install grill.
Failure to do so can result in back
or other injury.
Natural Gas Use
This installation must conform with local
codes and ordinances**. In the absence of
local codes, installations must conform
with either the National Fuel Gas Code
ANSI Z223.1, or CAN/CGA-B149.1*
Natural Gas and Propane installation code.
8
1.
Place grill into outdoor enclosure,
but leave enough room in back to connect
to gas supply.
2.
Make gas connections.
A combination of pipe fittings must be
used to connect the grill to the existing
gas line.
1/2" grill
rear of
gas pipe
grill
flexible gas
connector
• If local codes permit, use a flexible
stainless steel tubing gas connector,
design-certified by AGA or CSA
International, to connect the grill to the
rigid gas supply line. 5/8" diameter line is
recommended. Using a wrench to
tighten, connect the gas supply to the
grill. Use pipe joint compound on all non-
flared male threads. Do not kink or
damage the flexible connector when
moving the grill.
• Pipe-joint compounds suitable for use
with L.P. gas must be used. Do not use
Teflon
®
tape.
valve open
3.
Open shutoff valve in the gas supply
line. The valve is open when the handle is
parallel to the gas pipe.
Test for gas leaks.
Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak. Correct
any leak found.
Copies of the standards listed may
be obtained from:
* CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
** for local codes, contact your local
building inspector
4.
Open the hood.
5.
For models equipped with
rotisserie, remove the rotisserie's
skewer from the grill.
6.
Carefully lift grill grates off of grill
area and set aside.
hole in
rear panel
7.
Remove sear plates and set aside.
remove
tiedowns
valve closed
8.
Remove tiedowns from burners
and warming shelf.
® Teflon is a registered trademark of E.I. Du Pont
de Nemours and Company.
sear plate
warming
shelf
remove
tiedowns
burner
Advertisement
