Remote Control - Sony HT-XT100 Operating Instructions Manual

No sound is output from the connected
BLUETOOTH device.
 Make sure that the BLUETOOTH
indicator (blue) is lit (page 19).
 Bring this system and the
BLUETOOTH device closer together.
 If a device that generates
electromagnetic radiation, such as a
wireless LAN equipment, other
BLUETOOTH devices, or a
microwave oven is nearby, move
the device away from this system.
 Remove any obstacle between this
system and the BLUETOOTH device
or move this system away from the
obstacle.
 Reposition the connected
BLUETOOTH device.
 Try changing the wireless frequency
of the Wi-Fi router, computer, etc.
to 5 GHz band.
 Increase the volume on the
connected BLUETOOTH device.
The sound is not in sync with the
image.
 When you are watching movies, you
may hear the sound with a slight
delay from the image.

Remote control

The remote control does not function.
 Point the remote control at the
center of the front panel (remote
control sensor) of the system
(page 19).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the
remote control with new ones, if
they are weak.
 Make sure you are pressing the
correct button on the remote
control (page 21).
Others
The Control for HDMI function does not
work properly.
 Check the HDMI connection (refer to
the supplied Startup Guide).
 Set up the Control for HDMI function
on the TV. Refer to the operating
instructions supplied with the TV for
TV setting.
 If you connect/disconnect the AC
power cord (mains lead), wait more
than 15 seconds before operating
the system.
 If you connect the audio output of
video device with the system, using
a cable other than an HDMI cable,
no sound may be output because of
the Control for HDMI function. In
such a case, set [CTRL (Control for
HDMI)] in [HDMI] to [OFF] (page 11)
or connect the cable from the audio
output jack of the video device
directly to the TV.
If [PRTCT] appears on the front panel
display of the system
 Press the / (on/standby) button
on the system to turn off the
system. After the display
disappears, disconnect the AC
power cord (mains lead) then check
that nothing is blocking the
ventilation holes of the system.
17
GB