Available Accessories - Elisa EAS428SS Installation Instruction Manual

Replacing the halogen lamp (EPR628SS models)
CAUTION: Before replacing the lamps, disconnect power off
to prevent from being switched on accidentally.
Turn off the range hood and allow the halogen / incandescent
lamp to cool. To avoid damage or decreasing the life of the new
bulb, do not touch bulb with bare fingers. Replace bulb, using
tissue or wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver and gently pry the light cover
loose.
3. Remove the lamp and replace with a 120-volt, 40-watt
maximum, halogen lamp made for a G-9 base.
4. Replace the light cover.
5. Reconnect power.
Replacing the incandescent lamps (EAS428SS models)
1. Disconnect power.
2. Use a Phillips # 2 screw driver to remove the lamp cover.
Remove it carefully from its housing.
3. Remove the damaged lamp bulb (turn counter clockwise) and
replace it with a new bulb. E12 Philips Lamp 120V, 40W.
Reconnect power.

Available Accessories

Recirculating Kit
If it is not possible to vent cooking fumes and vapors to the
outside, the range hood can be used in the non-vented
(recirculating) version, using a charcoal filter. Recirculation Kit
model number EXXRCK10 is available from the dealer or an
authorized parts distributor.
A
G
B
D
F
A. Ceiling
B. Vent cover
C. Soffit
D. 6" (15.2 cm) vent
E. Range hood
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow the
6" vent and vent cover to be seen.
1. Cover the grill that protects the suction motor with the carbon
filter so that the slots on the filter correspond to the pins on
the sides of the motor protection grill.
2. Turn the carbon filter clockwise to block them (bayonet fixing).
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
Extension Liner Kit
• 30" wide x 17" or 20" deep liner is available for both EAS428SS
and EPR628SS which provides complete protection of
cabinets (model number EXXHDL30).
• 36" wide x 17" or 20" deep liner is available for both EAS428SS
and EPR628SS which provides complete protection of the
cabinets (model number EXXHDL36).
See Liner installation instructions for more detail.
12
G
F
I
E
H
F. Cabinet
G.Wall
H. 12" (30.5 cm) min. cabinet height
I. 17" (43.2 cm) min. vent cover height
A
B
C
D
E
the