Sony DAV-DZ150K Operating Instructions Manual page 82

• If the picture output from your system goes
through your VCR to get to your TV, the copy-
protection signal applied to some DVD programs
could affect picture quality. If you still experience
problems even when you connect your unit
directly to your TV, try connecting your unit to
your TV's S video input (page 20).
Even though you set the aspect ratio in [TV
TYPE] of [SCREEN SETUP], the picture does
not fill the TV screen.
• The aspect ratio on the disc is fixed.
Color irregularity occurs on the TV screen.
The subwoofer and the front speakers in this system
are magnetically shielded to prevent magnetic
leakage. However, some leakage may occur, as a
high-strength magnet is employed. If this happens,
check the following items:
• If the speakers are used with a CRT-based TV or
projector, install the speakers at least 0.3 meters
(1.0 ft) from the TV set.
• If the color irregularity persists, turn off the TV set
once, then turn it on after 15 to 30 minutes.
• If howling occurs, reposition the speakers farther
away from the TV set.
• Make sure that no magnetic object (magnetic latch
on a TV stand, health care device, toy, etc.) is
placed near the speakers.
Sound
There is no sound.
• The speaker cord is not connected securely.
• Press MUTING on the remote if "MUTING ON"
is displayed in the front panel display.
• The system is in pause mode or in Slow-motion
Play mode. Press H to return to normal play
mode.
• Fast forward or fast reverse is performed. Press
H to return to normal play mode.
• Check the speaker settings (page 76).
The left and right sounds are unbalanced or
reversed.
• Check that the speakers and components are
connected correctly and securely.
There is no sound from the subwoofer.
• Check the speaker connections and settings (page
10, 76).
• Set the sound field to "A.F.D. STD
Severe hum or noise is heard.
• Check that the speakers and components are
connected securely.
82
GB
• Check that the connecting cords are away from a
• Move your TV away from the audio components.
• The plugs and jacks are dirty. Wipe them with a
• Clean the disc.
The sound loses stereo effect when you play a
VIDEO CD, a CD, or an MP3.
• Set [AUDIO] to [STEREO] by pressing AUDIO
• Make sure the unit is connected properly.
The surround effect is difficult to hear when
you are playing a Dolby Digital, DTS, or MPEG
audio sound track.
• Make sure the sound field function is on
• Check the speaker connections and settings (page
• Depending on the DVD, the output signal may not
The sound comes from the center speaker
only.
• Depending on the disc, the sound may come from
No sound is heard from the center speaker.
• Check the speaker connections and settings (page
• Make sure the sound field function is on
• Depending on the source, the effect of the center
• A 2 channel source is being played.
No sound or only a very low-level sound is
heard from the surround speakers.
• Check the speaker connections and settings (page
• Make sure the sound field function is on
• Depending on the source, the effect of the
• A 2 channel source is being played.
Microphone sound is not output.
• A function other than DVD is selected.
• The microphone is not connected to the unit
" (page 29).
• The microphone volume is set to minimum.
transformer or motor, and at least 3 meters (10 ft)
away from your TV set or a fluorescent light.
cloth slightly moistened with alcohol.
(page 38).
10, 76).
be the entire 5.1 channel. It may be monaural or
stereo even if the sound track is recorded in Dolby
Digital or MPEG audio format.
the center speaker only.
10, 76).
speaker may be less noticeable.
10, 76).
surround speakers may be less noticeable.
properly.
.
(page 29)
.
(page 29)
.
(page 29)