CONTENTS BM SERIES BENCH/FLOOR SCALE INSTALLATION OPERATION MANUAL SPECIFICATIONS PLEASE READ THIS INSTRUCTION MANUAL VERY CAREFULLY BEFORE ATTEMPTING TO OPERATE KEYBOARD LAYOUT AND DESCRIPTION THIS SCALE INSTRUCTIONS FOR USE TROUBLE SHOOTING DAILY CARE AND MAINTENANCE June 2010 REV 1 INSTALLATION DIAGRAMS Specifications subject to change without prior notice...
INSTALLATION Power on the Scale CHECK and make sure that the following 1.3.1 Check the input voltage of the main accessories are included inside the adapter/scale matches with the voltage package. of electricity outlet. Contact your This Operation Manual, Indicator x 1, local dealer if not.
2. SPECIFICATIONS 3. KEYBOARD LAYOUT AND DESCRIPTION GENERAL SPECIFICATIONS Model No. Capacity Division BM-30 66 lb 0.01 lb BM-60 132 lb 0.02 lb BM-150 330 lb 0.05 lb 13 x 17.7 x 3.5” Platform size Power source Built-in rechargeable battery or power adaptor Max.
Page 4
Press this key to recall the accumulated weight 11. WEIGHT UNIT INDICATOR value in memory. "kg"indicatesthemetricunitisbeingemployed. "lb" indicates the avoirdupois unit is being 5. TARE KEY employed. Press this key to tare off the weight of a container and get the net weighing result. 12.
4. INSTRUCTIONS FOR USE press and hold TARE, then press ON/OFF. Scale displays “F.1” PLACING SCALE press TARE twice. Scale displays ”F.3” Usethisunitonahardandstrongsurface, press and hold MODE where is free from RF interference, press MODE unit the “lb” signs appear(or vibration, fire, direct sunlight and select “kg”...
Page 6
is being employed. PLACING A LOAD Always place a load onto the platform 4.8.2 Recall Weight Accumulated gently. Sudden shock/excessive force Press MR, scale displays total number may cause damage to the weight sensor of entries and total accumulated weight inside.
press and hold TARE, then press ON/OFF. SYNDROME SCALE CANNOT BE TURNED ON Scale displays “F.1” CHECK Is the rechargeable battery charged? press TARE for three times. Scale ACTION Recharge the battery for at least displays “F.4” hours plug mains press MODE to select: adapter/input.
ACTION Turn scale off, remove all loads mains adapter/input. from platform and turn of again. 00000 CHECK Anything obstructing the platform? SYNDROME SCALE DISPLAYS “ ” ACTION Remove all obstacles. CHECK Is the weight of load excesses the max. capacity? SYNDROME SCALE DOES NOT WEIGH CORRECTLY ACTION...
7. INSTALLATION DIAGRAM BM or FM & LM Do not use any harsh, abrasive material, acetone, volatile solvent, thinner or alcohol for cleaning. Verify accuracy scale periodically. Re-calibrate the scale when needed. NOTE: some countries calibration restricted to be done by qualified/authorized agent only.