Operating Instructions; Initial Positioning And Installation; Operation - Probasics 7050 Operator's Manual

1. Select a suitable location for the unit near a 120 VAC, 15 Ampere, grounded power
outlet.
2. Grasp handle on top of cabinet and position the unit so that operating controls are
Accessible to the user and back of unit is away from wall.
3. Make certain that the power switch located in the center of the control panel is in the
OFF position (Figure 1) and plug power cord into grounded power outlet or grounded
adapter.
4. Be certain that all connections to outlet ( i.e. tubing , nebulizers , etc.) are snug and
not leaking aerosol.
5. When used in conjunction with mist tents, etc., place unit outside of tent and place unit
at a level below discharge end of the delivery tubing.
1. Press Power On/Off switch to ON position (figure 1).
2. Connect the equipment you intend to use with the Probasics Model 7050 compressor
and then adjust the pressure that the unit is delivering by adjusting the regulator (figure 1)
as follows:
a. Pull regulator knob out to unlock adjustment.
b. Turn dial of regulator to desired pressure.
-clockwise – increase pressure
-counter clockwise – decrease pressure
c. Push knob towards unit locking regulator pressure.
...and observe the pressure gauge – adjust up or down to desired output pressure.

OPERATING INSTRUCTIONS

INITIAL POSITIONING AND INSTALLATION

OPERATION

4