Any tampering by unauthorised persons will render this warranty void. In the event that you need to claim warranty, please take the complete device together with all information and the invoice to one of our dealers or send it in to Umarex-Laserliner. ENGLISH...
Page 4
DuraMax (4 x Model 06.2007) Prism head X axis display Control panel Auto/man button Tilt display Battery compartment Tilt button 5/8” thread (bottom) Y axis display M Battery charge display Operating / Battery display N Charger socket ON / OFF button O Quick sighting Receiver window for remote control...
Page 5
DuraMax SensoCommander (optional) - Accessory The SensoCommander is an all-in-one remote control and laser receiver unit. SensoCommander 120: SensoCommander Pro 310 (Diodes also on the back) (screwed) RoundLite Signal SensoCommander Pro 200 / 300 Transmitter (optional) This system is ingeniously simple: RoundLite and SensoCommander Pro RF communicate with each...
DuraMax Self-Levelling-System (SLS) The AutoControl-Master ACM is of the self-levelling kind. After it has been put in the required basic position, fine adjustment is being effected automatically. Horizontal and vertical orthogonal adjustments are effected by the self-levelling system (SLS), while the X-axis and the Y-axis are scanned by two electronic measuring sensors.
Page 7
DuraMax Operation of the DuraMax Charging the batteries • Before using the DuraMax, fully charge the batteries • Open the battery compartment (K), insert the batteries and connect the plugs to the sockets. The plugs fit in the sockets in one position only (see pictures on right).
DuraMax Operation Setting up: Position the device on a level surface or on a tripod. • Press the "ON/OFF" switch. • The device automatically levels itself within a range of ± 5°. When levelling has been completed, the laser rotates at maximum speed. The DuraMax is in hand receiver mode.
Page 9
DuraMax Working with the SensoCommander (optional) Control panel SC 120 / Pro 14 Switchover between X and Y axes in tilt or calibration mode 15 Sound volume / axis adjustment in tilt or calibration mode 16 Hand receiver mode 17 Save calibration Note: The laser receiver has two tolerance settings: Precision and free-hand setting.
Page 10
Note: If points A2 and A3 are more than 1 mm / 10 m apart on either the X or Y axis, the device is in need of calibration. Contact your authorised dealer or else the UMAREX-LASERLINER Service Department. ENGLISH...
Page 11
DuraMax Recalibration 1. To recalibrate the device, you need an additional remote control or an additional SensoCommander (except SensoCommander Classic). Position one SensoCommander at the height of reference point A2 (see the two previous pages). Then perform calibration with the other. 2.
Page 12
DuraMax Technical Data (Subject to technical alterations). DuraMax Self-levelling range + 5° approx. 30 sec – on entire working Adjustment speed angle Precision + 1 mm / 10 m Sensor Electronic levelling device Horizontal levelling Automatic Rotation speed 500 RPM Remote control Infrared IR Laser wavelength...