Any tampering by unauthorised persons will render this warranty void. In the event that you need to claim warranty, please take the complete device together with all information and the invoice to one of our dealers or send it in to Umarex-Laserliner. ENGLISH...
Page 4
AutoCross-Laser ACL 3 RX Laser exit window Control panel Battery compartment (on back) ON / OFF switch Transport securing device 1/4” thread (ACL 3 RX: bottom of housing) Base (rotatable) 5/8” thread (bottom of housing) Adjusting plate for plumb function Centring holes for plumb function Hand receiver mode...
Page 5
AutoCross-Laser ACL 3 RX A Power indicator B Switch accuracy short range / long range C LED for accuracy green / red D ON / OFF switch E Sound ON / OFF F Receiver field for laser beam G LED’s for Laserindication (front, side, backside) H Universal mount Battery compartment (backside)
Page 6
AutoCross-Laser ACL 3 RX Plumb definition: Through the laser cross at the top, a plumb line can be projected from the floor to the ceiling. To do this, centre the adjusting plate on the desired projection point. Then screw the base (6) onto the device and position in the centring holes (9) of the adjusting plate (8).
Page 7
AutoCross-Laser ACL 3 RX Universal mount: The laser receiver RX 50 can be fitted on measuring staffs with the universal mount. The Flexi measuring staff (Art. No. 080.50) is always recommended when measuring from floor heights. It also allows you to determine heights directly without any need for calculation.
Page 8
Note: If points A2 and A3 are more than 2 mm / 10 m, the device is in need of calibration. Contact your authorised dealer or else the UMAREX- LASERLINER Service Department. Checking the vertical line: Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m length on the wall, making sure that the bob...