Led Indicator Lights - Lightwave JSJSLW930 Instruction Manual

Lightwave Link Installation Guide

LED Indicator lights

The LED indicators are used to indicate the status of the Link and to
indicate if there is a problem. If there is a problem reported, it will usually
refer to an insecure cable connection or a server connection problem. If it
has been set up correctly, the App will display details of any specific
problem. See www.lightwaverf.com for support. There are three states:
green, amber and red.
Steady Green: Status normal
Flashing Green: Transmitting
Flashing Green/Amber: Linking mode
Steady Red: Cannot contact server
Flashing Red: Cable / router problem
Registering/De-Regestering Devices
Once the App is downloaded and set up, you will be able to register multiple
smartphones / tablets to use it (see in-App instructions).
De-registering / Factory Reset
To de-register all linked smartphones / tablets devices, and to return the
Lightwave Link to factory settings, press and hold the Reset button on the
rear of the device for 10 seconds. When the LEDs flash red / green, press the
Link button. The LED will flash red ten times to confirm the reset.