Advertisement
(2) Do not over reach.
(3) Keep proper footing and balance at all times.
(4) Don't let the nose of the guide bar contact a log, branch, ground. or other obstruction.
(5) Don't cut above shoulder height.
(6) Use devices such as special guide bars that reduce the risks associated with kickback.
(7) Only use replacement bars and chains specified by the manufacturer.
16. Replacement Parts
When servicing use only identical replacement parts.
17. Before making a felling cut, remove dirt, stones, loose bark, nails, staples and wire from the tree.
18. Secure the log so that it will not roll or move suddenly during operation.
19. AVOID UNINTENTIONAL STARTING. Don't carry tool with finger on switch.
Be sure switch is in OFF position before inserting battery cartridge.
20. The chain saw must not be left outdoors during rain and it must not be used when wet.
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER & BATTERY CARTRIDGE
1. Save these instructions.
2. Before using battery charger, read all instructions and cautionary markings on battery
charger, battery and product using battery.
3.
CAUTION: To reduce risk of injury, charge only Wel-Bilt Battery Cartridge. Other types
of batteries may burst causing personal injury and damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold by the battery charger manufacturer may
result in a risk of fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
7. Make sure cord is located so that it will not be stepped on, or tripped over. Otherwise it will be
subject to damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock.
9. Do not operate charger with damaged cord or plug - replace them immediately.
10.Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
11.Do not disassemble charger or battery cartridge; take it to a qualified serviceman when
service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
12.To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
FOR CHARGER & BATTERY CARTRIDGE
1. Do not charge Battery Cartridge when temperature is BELOW 50°F (10°C)
or ABOVE 104°F (40°C ).
2. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
3. Do not allow anything to cover or clog the charger vents.
4. Always cover the battery terminals with the battery cover when the battery cartridge is not used.
5. A battery short can cause a large current flow, overheating, possible burns and even
a breakdown.
(1) Do not touch the terminals with any conductive material.
3
MAINTENANCE
CAUTION:
•
Always be sure that the machine is switched off and the battery cartridge is removed
before carrying out any work on the machine.
•
Always wear gloves when performing any inspection or maintenance.
Filing saw chain
File the saw chain so that the cutters meet the specifications indicated in illustration.
1) Filing cutters
Use a round file 4 mm in outer diameter to file the cutters. Apply it to the cutter so that
it will be angled 30° to the guide bar and protrude 1/5 of the outer diameter from the tip
of the cutter. Hold the file level and push it away from you while filing. Be careful not to
touch the cutters with the file when pulling it back toward you.
2) Filing depth gauges
Use a flat file to file the depth gauges. Hold the file level while filing.
Round off the front corner of the depth gauge to maintain its original shape.
After filing the saw chain, immerse it in oil and wash off filing chips and sawdust from
the saw chain.
8
Advertisement
