Table of Contents
Advertisement
iNSTaLLaTiON
Continued
Operating Optional Blower GA3500A
Light your gas appliance with the blower off. After
about 10 minutes, turn the blower on to deliver
heated air out the top louvers. The blower features
a variable control which allows you to select the
blower speed you desire.
Note: Periodically check the louvers of the firebox
and remove any dust, dirt or obstructions.
Speed
Control
Shaft
Lock
Control
Nut
Knob
Figure 18 - Installing Optional Blower
GA3500A
HEAT DEFLECTIVE HOOD
INSTALLATION
The factory supplied heat deflective hoods must
be installed inside the fireplace opening on both
sides for the safe operation of the unit as shown
in Figure 19.
1. Remove protective covering from hoods.
2. Position deflective hood into opening on one
side of the firebox and secure to the top of the
opening using screws provided.
3. Secure the ends of the hood to the firebox
using two screws (provided) for each side.
4. Repeat steps 2 and 3 to install hood on the
remaining side and end of the firebox.
CAUTION: Do not clean hood
with abrasive cleanser. Use only
regular household cleaners and
a smooth cloth.
14
Receptacle
Blower
Hook and Loop
Mounting Strips
www.desatech.com
Front Hood
(Typical Each Side)
Corner
Post
2 Screws Each
End of Hood
Figure 19 - Typical Hood Installation
(Both Sides)
OPERaTiNg gUiDELiNES
aND MaiNTENaNCE
iNSTRUCTiONS
When lit for the first time, a vent-free log heater will
emit a slight odor for about an hour or two. This is
a normal occurrence which is due to the "curing"
of the logs and the "burn-in" of internal paints and
lubricants used in the manufacturing process.
Keep control compartments, logs, burners and
areas surrounding the logs clean by vacuuming or
brushing at least twice a year. Temporary removal
of the log set may ease the cleaning of the burner
and pilot assembly. In cleaning, take care not to
alter the settings on the pilot assembly. See the
operating instructions supplied with your vent-free
log heater for additional cleaning instructions.
WARNING: Logs can be very
hot! Allow logs to cool before
handling.
IMPORTANT: Turn off the gas supply at the exter-
nal shutoff valve before servicing appliance. Any
safety screen or guard removed for servicing must
be replaced prior to operating the appliance.
Installation and repair should be done by a quali-
fied person. The appliance should be inspected
before use and at least annually by a professional
service person. More frequent cleaning may be
required due to excessive lint from carpeting, pet
hair, etc. It is imperative that the control compart-
ments, burners and circulating air passageways of
the appliance be kept clean.
3 Screws
(Top)
105163-01C
Advertisement
Table of Contents
