Tuning The Tv To Your Unit - Panasonic NV-VP60 Series Operating Instructions Manual

Tuning the TV to Your Unit

The unit supplies a signal to the TV via the RF coaxial cable on
channel E21sE69. It is possible to view the unit's picture on your TV
in the same way that you watch TV broadcasts. The unit is fitted with
its own tuner (just like a normal TV) and can be preset to receive up
to 99 TV broadcast stations.
≥Press [VHS SELECT] (l 8).
¬ If you have connected the unit to the TV through the audio/
video output sockets
You do not need to follow the procedure below. To view the pictures
from the unit, set to the AV mode on the TV with [AV].
Plug in Auto Tuning
When the unit is turned on after
connecting the aerial cable and the
mains lead for the first time, tuning
starts automatically.
≥If the unit is turned on with the aerial not
connected, all channels are skipped.
.................................................................................................................................
[1]
Press [ÍVHS] to turn on
this unit.
.................................................................................................................................
[2]
Set the TV to an unused
position for the unit
viewing channel.
≥Tune the TV until the display shown
on the right appears. Refer also to
the TV's instructions regarding tuning.
≥Set "RF SELECT" by pressing [2 1] to select the colour TV
system used by the TV set to be connected.
BG: PAL B.G.H/SECAM B.G
I: PAL I
DK: PAL D/SECAM D.K.K1
.........................................................................................................................................................................................................................
[3]
Press [MENU].
ª To cancel Auto Tuning halfway through
Auto Tuning will stop halfway by turning the unit off, pressing
[MENU], playback or power failure.
¬ If Auto Tuning stops halfway by turning the unit off, playback
or power failure
≥Disconnect the mains lead and then reconnect it.
≥Turn on the unit. Plug in Auto Tuning restarts.
¬ To set the channels manually (l 20)
ª To restart Plug in Auto Tuning
≥Turn the unit on.
≥Make sure there is no video cassette in
the unit.
1) Keep both [ICH] and [JCH] on
the unit pressed simultaneously for
3 seconds or more until the channel
on the unit's display changes to 1.
2) Disconnect the mains lead and then reconnect it.
3) Turn on the unit. Plug in Auto Tuning restarts.
Downloaded From Disc-Player.com Panasonic Manuals
12
12 RQTV0115
To Change the RF Output Channel
You can change the RF output channel, for example, when
interference occurs on the picture after tuning.
.........................................................................................................................................................................................................................
[1] Press [MENU] for 5
seconds or more.
.................................................................................................................................
[2] Press [JCH] or [ICH]
to select the channel
(E21sE69).
≥Each time you press [JCH] or
[ICH], (l below).
≥Set to "ss" (RF OFF) when you
use the Audio/Video cable for the
connection.
≥You can also use the numeric
buttons.
CH 22 SEARCH 21 Example: "28"; [2]l[8]
END : MENU
.............................................................................................
[3] Retune your TV to
the new RF channel
for the unit.
.............................................................................................
AUTO TUNING S
COMPLETED.
[4] Press [MENU] to exit
RF SELECT BG DK
the setting mode.
RF SELECT : END : MENU
Note:
≥Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
1
Disappears
Panasonic
RF SELECT BG I DK
RF SELECT :
END : MENU
21 69
(RF OFF)