JVC KD-DV5105 Service Manual page 9

QQ
3.1.5 Removing the rear bracket 3 7 63 1515 0
(See Fig.6)
• Remove the bottom cover.
(1) From the back side of the main body, remove the two
screws E, two screws E', screw F, two screws G and three
screws H attaching the rear bracket.
(2) Remove the LINE IN cable from the rear bracket in the di-
rection of the arrow.
Reference:
• When attaching the LINE IN cable, insert it in a slot of the
rear bracket and hang it on a wire holder.
• When attaching the screws E', attach the cable holders with
them.
3.1.6 Removing the main board
(See Figs.6 and 7)
• Remove the front panel assembly, bottom cover, front chassis
assembly and side heat sink.
Reference:
Remove the rear bracket as required.
(1) From the back side of the main body, remove the three
screws H attaching the main board. (See Fig.6.)
(2) From the bottom side of the main body, remove the three
screws J attaching the main board. (See Fig.7.)
(3) Disconnect the connector
the DVD mechanism assembly and take out the main
board from the main body. (See Fig.7.)
TE
L 13942296513
3.1.7 Removing the DVD mechanism assembly
(See Fig.8)
• Remove the front panel assembly, bottom cover, front chassis
assembly, side heat sink and main board.
(1) From the inside of the top chassis, remove the three
screws K attaching the DVD mechanism assembly.
(2) Take out the DVD mechanism assembly from the top chas-
sis.
www
.
http://www.xiaoyu163.com
CN961 on the main board from
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
LINE IN cable
Rear bracket
Cable holder
E'
H
F
J
Q Q
3 6 7 1 3 1 5
DVD mechanism assembly
K
co
.
9 4 2 8
Slot
Wire holder
Cable holder
H E'
Rear bracket
G E
Fig.6
CN961
0 5 8 2 9 9 4 2 8
Main board
Fig.7
m
Top chassis
K
Fig.8
(No.MA150)1-9
9 9
E
H
J
9 9
J
K