Assembly - ProGo 3000 Operator's Manual

4.1 INSTALLING THE HANDLEBAR
Your PROGO® scooter is packaged separately from the handlebar.
Before using your PROGO® scooter, you
must properly install the handlebar:
1. Unless it is already screwed into the
stem core, pass the bolt through the
latch and screw a few threads clockwise
into the stem core (fig. 1).
2. Position the handlebar with the latch
above the front wheel and insert the
stem core into the stem base (fig. 1).
3. Screw the bolt clockwise all the way in to
secure the handlebar in its place.
4.2 FOLDING FEATURE
Your PROGO® is equipped with a folding feature for easy carrying and stowage.
Before operating the scooter:
1. Pull the handlebar up to an upright position.
2. Screw the latch knob clockwise all the way in to secure the handlebar in its position.
3. To fold your PROGO® scooter, reverse the process.
WARNING: The "Lower Hinge" of the latching mechanism is also a
"Mechanical Fuse" designed to break if there is high shock loads, stress,
and/or fatigue exerted on the handlebar assembly. If the handlebar feels
abnormally loose or sloppy, you must immediately stop riding and have the
scooter serviced. Failure to ignore this safety feature could result in a
catastrophic failure causing a sudden loss of control.
SECTION 4: ASSEMBLY
8
Fig. 1