Initial Parameter Set Up - Chargery Power 550B Operating Instructions Manual

Initial parameter set up

CY-550B will be operated with the default value of the essential user settings when it is connected
to a 12V battery or a 12V adapter for the first time. The LCD displays the following information in
sequence and the user can change the value of parameter on each step. When you are willing to
alter the parameter value in the program, press
the value with DEC or
.
User Config
Program
Start/ Enter
Temp shut off
ON 80℃
DEC INC DEC INC
Charging time
ON 010min
DEC INC DEC INC
Capacity charged
ON 3000mAh
DEC INC DEC INC
Push Button ON
Buzzer ON
DEC INC
Low Input Power
on 10.7V
DEC INC
Back-light
78%
DEC INC
www.chargery.com
LiPo Smart Balance Charger
INC button. The value will be stored by pressing
This is star screen.
An optional feature using temperature probe contacts the surface of battery. The feature can
be on or off. If it is on, set the maximal temperature at which the charger allows battery to
reach during charge. Once the battery temperature reaches the limit while charge, the
charging will be ended to protect the battery
When you start a charge process, the integral safety timer automatically starts running at the
same time. This is programmed to prevent overcharge the battery if it proves to be faulty or
if the termination circuit can not detect the battery full charged. The value should be
generous enough to allow a full charge of the battery
The program sets the maximal charge capacity that will be supplied to the battery during
charge. If the termination circuit can not detect the battery full charged, this feature will
automatically stop charging at the set capacity value.
The beep sounds at every time pressing the buttons to confirm your action. The beep or
melody sounded at various times during operation to alert different mode changes. These
audible sounds can be on or off.
The program monitors the voltage of battery used as input power. If the voltage drops below
the value you set, the charging process will be terminated forcibly to protect the battery.
You can adjust the brightness of LCD screen at the charger.
start/enter button to make it blink then change
CY- 550B.
start/enter button once.
page 4 total 11