GEMEL Serpi Star ND 5 Operating Instructions page 2

Congratulations! You have chosen a SERPl STAR car alarm, a truly outstanding product. Please take the
5)
DISARMING THROUGH REMOTE CONTROL
time to read thls manual as it is indispensable. Locate the system, that is hi-lighted on the cover, in the chart
on page
1.
On the left of the chart is the function column numbered 1 to 25. The stars under your alarm
~ ~ ~ : ~ i ~ ~ ) ~ ~ ~ ~ , $ ~ ~ ~ Y b ~ : r e s s i n g push-butt0n (A)'
indicate the section numbers you need to refer to learn about the features associated with that system.
-
1 flash of the d~rection liahts facility:
I buzzer sound:
o
( w i t h GR48 version only with GS3A98 siren)
@ Function to b e selected a t the time o f installation.
Doors w ~ l l unlock ( ~ f thls functlon
IS
connected).
# In the Belgium version these functions are masked a n d cannot b e changed.
-
The dashboard LED will extinguish.
1
The alarm can b e integrated with additional modules, i.e. Shock sensor (GMS), Anti-Tilt
(Only with GR 48 versions) - It w ~ l l be poss~Dle to illum~nate the ceiling lamp for about 20 seconds.
if
the
(GMA), Window lift, Ultrasonic & Bi-volumetric modules (this function i s already included
veh~cle allows this.
in GR48) a n d Engine immobiliser (This function is already included the NDS, ND6, a n d GR48).
6)
ARMING THROUGH ELECTRONIC KEY
(GR48 Only)
\
1)
ROLLING CODE TRANSMITTERS
Today's technology has enabled these alarms to be manufactured with a rolling code system. The codes are
changed randomly every time the ONIOFF button is pressed. This guarantees the highest level of security
available against any attempt to scan or grab the activating code. It is possible to have up to a maximum of 4
transmitters programmed to the system at any one time. Each time the ignition swltch
IS
turned OFF the
alarm LED will flash once for each transmitter programmed.
In the event of a transmitter being lost or stolen, the remaining transmitterls can be reprogrammed to the
alarm thus cancelling the lostlstolen transmitter.
If a transmitter appears to be workinq but does not activatelde-activate the alarm, refer to the
It is also possible to arm the alarm system with the Electron~c Overr~de key
by touching the key end onto the dashboard LED. When armed with thls
key the doors will not lock and the Car Check function will not be available.
The acoustic alarm will be operative only after 45 seconds. When arming
with the Electronlc Override key there will be a delay of 5 seconds the
following circuits:
- Door push-button:
- UltrasoniC5:
-
Voltage Diop.
@
RE-SYNCHRONISATION section. -
2)
ARMING THROUGH REMOTE CONTROL
Press push-button (A).
The alarm armlng will be signalled by:
- 2 flashes of direction lights facility:
- 2 audible tones;
@
(With GR 48 version only with GS3A98 siren)
- Doors will lock (if this function is connected):
- Windows will close, (when connected), by keeping the push-button pressed up
to the wished position): @
- lllumination of the alarm LED. After 45 seconds it will start to flash.
NB During the
45 seconds arming period, triggering any of the alarm lines will be
signalled by a single audible tone (with GR48 version only with GS3A98 siren)
and a short extinction of the dashboard LED.
7 )
DISARMING T.HROUGH ELECTRONIC KEY
(GR48 Only)
It is possible to disarm the alarm system using the Electronic Override key by touching the key end onto the
AA
dashboard LED.
PANIC ALARM @
( ~ c o u s t i c alarm only)
This funct~on is activated for 5 seconds by pressing push-button (6) 45 seconds after the armlng period or
with the alarm is in the disarmed state It can be deact~vated by presslng the push-button ( 0 ) again (wlthout
' t h e alarm condi' n )
DASHBOARD LED
The Dashboard
LED
has the lollowlng functions:
-
It signals the armlng time (flrst 45 seconds after arming the system) with a static signal:
-
It signals the change from the arming time to the fully armed state by startlng to flash:
-
It sianals the exclusion of the siren sound;
3)
OPTIONAL MODULE EXCLUSION iND5. ND6, ND14)
''.
Arm the alarm system and then press push-button (6).
If this operation
IS
carrled out wlthin 45seconds from the arming, all the installed optional sensor modules
are excluded.
The exclusion will be signalled by-
-
3 buzzer sounds: @
-
3 flashing lights of direction lights facility:
-
3 flashes of the LED.
-
It signals the number of programmed remote controls and electronic keys (only on GR48), each flash
signals one remote control programmed and two seconds after the first signalling 11 signals number of
electronic override keys programmed each time you switch the engine off);
-
It signals the alarm memory;
-
It signals alarm causes dur~ng armlng tlme:
- Selectionlconfirmation during function
programming.
- It signals the passive and anti-distraction arming.
Also, during the 45 second arming period it is possible to test the alarm to ensure correct operation
Activatina the various alarm trlaaers durina this oerlod will be acknowledaed bv a buzzer tone and the
dashboaFd LED WIII flash
the sysiem after 45 seconds
WIII
cause t i e maln slren to sound
4)
U.S.. SHOCKS AND ANTI-TILT OPTIONAL MODULES EXCLUSION
(Onlv for GR481
. .
The ultrasonics and optional modules can only be excluded during the first 45 seconds from the alarm
arming, this can be done by one of two separate actions. Arm the alarm system and press the push-button
(0). The ultrasonics are excluded when pressing the push-button for the first tlme.
The exclusion will be signalled by:
-
3 buzzer sounds: @(Only wlth GS3A98 siren)
-
3 flashes of the direction lights facility;
-
3 flashes of the dashboard LED.
By pressing the (6) push-button again, you will exclude any remaining optional modules. The alarm confirms
thls exclusion, by repeating the above signals.
10)
ENGINE IMMOBILISER AUTOMATIC ARMING (PASSIVE FUNCTION)
€ 3 #
(If connected and enabled by programming)
The immobiliser
IS
automatically engaged 16 seconds after the ignition 1 s turned OFF and the drlver's door
opened and closed If the door is not opened then the immobiliser will be engaged after 5 minutes. activation
will be signalled by.
-
1 flash of direction lights:
-
1 buzzer sound; @ (With GR48 version only with GS3A98 siren)
- lllumination of the LED