Netopia Cayman 3346-ENT Quick Start Manual page 7

3. Configure the Netopia Cayman
If your ISP uses PPPoA, follow the instructions (the example below is based on
ADSL "Wires Only" in the UK - parameters may change according to your ISP):
Trellis Coding Enabled:
Fast Retrain Enabled:
Wiring Type
Data Link Encapsulation
PPP Mode
Data Circuit VPI (0-255)
Data Circuit VCI (32-65535)
PREVIOUS SCREEN
Return/Enter takes you back to previous screen.
If necessary, toggle PPP Mode from VC Multiplexed to LLC SNAP and change the
VPI and VCI to match those used by your Internet Service Provider.
Please note:
This example is based on ADSL "Wires Only" in the UK. ADSL "Wires Only" uses
PPPoA and different VPI/VCI than those by default. As a result, you need to set
Data Link Encapsulation to PPP, VPI to 0 and VCI to 38. PPP Mode remains VC
Multiplexed by default. Parameters may change according to your ISP!
Proceed to the next screen.
C/ The Connection Profile 1: Easy Setup Profile screen appears.
The example below is based on IP Easy Set Up using NAT by default.
Connection Profile 1: Easy Setup Profile
Address Translation Enabled:
IP Addressing...
Remote IP Address:
Remote IP Mask:
PPP Authentication...
Send Host Name:
Send Secret:
PREVIOUS SCREEN
Return/Enter brings you to next screen.
Enter basic information about your WAN connection with this screen.
Set the Remote IP Address to 127.0.0.2 - this will allow the Netopia Cayman to
automatically pick up the IP address of the remote gateway of your Internet Service
Provider. If you know this address, you can also enter it here.
Set PPP Authentication to the mode used by your ISP. In the BT Wires Only example
this would be CHAP mode. In the Send Host Name and Send Secret fields, enter
the login and password supplied by your ISP. Proceed to the next screen.
ADSL Line Configuration
login
password_
On
On
AutoSense
PPP
VC Multiplexed
0
38
NEXT SCREEN
Yes
Unnumbered
127.0.0.2
255.255.255.255
CHAP
NEXT SCREEN
(continued)
Make any
changes
that your
ISP requires.
Select NEXT
SCREEN and
press Return.
Make any
changes
required.
Select NEXT
SCREEN and
press Return.
E
N
G
L
I
S
H
7