Basic Operation; Battery And Charger; Basic Use; Connection With Computer - carNAVi S 500 Hardware Manual

3 Basic Operation

3 1 Battery and Charger

3.1.1 Power Supply
In-vehicle/portable GPS navigation has two ways of power supply: battery supply and power
supply.
When the device doesn't connect with the adaptor, it is supplied by the lithium battery. The
icon at the top right corner on the main interface of system indicates the current
remaining power.
When the device connects with the adaptor, it is supplied by the outer power.
【Tips】
Under normal condition(volume and backlight at 50％), it
can last about 2.5~3.5 hours after the battery is fully charged. Some
functions need to consume a lot of battery energy, such as
Tips
audio/video playing, high backlight and Bluetooth, which may reduce
the using time.
3.1.2 Car Charger
1. Connect one end of the car charger with power input jack of device.
2. Connect the other end with the cigarette lighter of the car in order to supply power and
charge up the device at the same time.
【Caution】
Please insert the car charger after car starting up in order
to avoid the damage of the device while starting up.
Caution

3 2 Basic Use

3.2.1 Power Key
1. Power on:
When the GPS power is full or after connecting the device with outer power supply, press the
power key for few seconds to start up.
2. Sleep mode:
When the device turns on, press the power key for several seconds to enter into sleep mode,
the GPS will automatically display the last state when next start-up.
-7-
3.2.2 Reset Key / Power-saving Key
When the system has no response, Press the reset button and then press Power key to re-
start the system, the performances are as below:
1. There are delay and stagnation during switch interface;
2. There is no response when click the icons.
3. Power key is unavailable.
【Caution】
Please backup the data before resetting the system.
Caution
3.2.3 Car Mount
The car mount consists of salver and bracket. While using the device in car the device should
be fixed in the proper position of fore-windshield.
【Attention】
Please choose the proper position to place the car
mount. Do not block the driver's view and place the device arbitrarily
without fixing; do not fix the device in the area that the airbag
Caution
3.2.4 Micro SD Memory Card
Correctly insert Micro SD card into the slot, and do not remove the Micro SD card during
operation.

3 3 Connection with Computer

Connect the device with computer by the USB cable. One end connects with PC and the
other end connects with the device.
1. Data transmission: There are two new "mobile disk" icons in "my computer" after the
device is successfully connected with computer, the first icon stands for the built-in flash
memory of the device, the second stands for the Micro SD card storage of the device. (If the
Micro SD card is not inserted, the second icon of the disk is unavailable). Then, you can use
them as normal USB flash disk.
-8-