TESTING THE KEYPAD PROGRAMMING 1. Enter programming mode Yellow LED 1. Connect the positive (=) lead of your 5 or 12VDC Press 99 # (master code ) * Flashes slowly power supply from the control panel to the terminal (TS1) =V input. or press sw1 switch 2.
Page 3
PROGRAMMING OPTIONS CHART If the pre-programmed default values must be changed or additional functions are desired, the following options may be programmed. 1. Enter programming mode Press 99 # (master code) * 2. Auto entry on (no * required) Press 30 # 2 # 1 # * * 3.
Page 4
This warranty shall expire two years after shipping date for Control DOOR-GARD keypads. Except as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without Panel limitation to, the condition of its products, their merchantability, or fitness for...
Need help?
Do you have a question about the Wiegand 272mp and is the answer not in the manual?
Questions and answers