The Final Drive Cross-Member; Final Drive Cross-Member-To Remove; Final Drive Cross-Member Mount-To Remove - Rolls-Royce Silver Shadow Workshop Manual

Rolls-Royce Silver Shadow t 9 Bentley T Series
Workshop Manual
0
chapter J
Section 53
THE FINAL DRIVE CROSS-MEMBER
Final drive cross-member-To remove
Normally, the final drive cross-member should not
require removal but, should the necessity arise, remove
it as follows.
1. Follow the procedure laid down under 'Final
drive unit-To
remove', carrying out Operations 1 to
-
-
-
10 inclusive.
O!
2. Unscrew
and
remove the two large nuts
and
44
heavy duty washers from the cross-member mount
f,
antre bolts and lower the cross-member from the car.
JJ
Note it may be necessary to lift the carpet in
the boot floor and hold the bolt heads
w h i l s t removing the nuts.
If'
the final drive unit is not to be separated from the
cross-member they may be removed together as a unit.
Final drive cross-member mount-To remove
1. To remove a h a 1 drive cross-member mount,
remove the cross-member as described previously, or
detach and lower the cross-member at least 6
in.
w
(15,24 cm.).
s
2. Remove the two setscrews securing the mount
0
support plate to the upper face of the cross-member
b
then lift the mount from its location (see Fig. J17).
Overhaul
FIG. 517 FINAL DRIVE CROSS-MEMBER MOUNT
1 Mount securing bolt
2
Distance tube
3 Body member
4 Cross-member mount
5 Securing nut and washer
6 Final drive cross-member
7
Mount securing bolts
8 Heavy duty washers