Advertisement
INSTALLATION INSTRUCTIONS - Page 15
Lift boiler onto the mounting bracket and adjust the boiler
position to obtain a minimum of 5mm clearance from any
side wall or cupboard.
Secure boiler to the mounting bracket using 5mm screw from
accessory pack A.
Undo the screws securing the transportation feet. Discard
feet and screws.
Correct vertical alignment with rear wall as necessary using
the adjustment screws
Remove the temporary cardboard packing pieces from either
side of the casing
Figure 10 LIFTING AND ALIGNING BOILER
Remove the four securing screws and withdraw the inner
draught diverter assembly. Check that the flueway baffles
are correctly located and retained in the flueways as shown
in Fig 10. Reassemble the draught diverter.
Make the flue connection to the boiler draught diverter
sealing the joint with a suitable compound. Refer to the
notes under FLUE page 6.
The weight of the flue must be supported independently
NOT by the boiler.
15
Hide quick links:
Advertisement
