Related Manuals for Applied Wireless VT900-3A
Summary of Contents for Applied Wireless VT900-3A
- Page 1 This page intentionally left blank. User’s Guide Instructions for Installation and Operation 900 MHz Video Transmitter Model VT900-3A 900 MHz Video Receiver Model VR900-3 Long Range Wireless Applications...
- Page 2 Product Descriptions the transmitter to a vertical surface. Also, keep in mind that the RF signal Model VT900-3A from Applied Wireless, Inc. is a high quality transmitter from the transmitter will travel through most non-metallic building designed to broadcast standard NTSC or PAL composite video signals to materials (wood, stucco, brick, etc.), however maximum stated reception...
- Page 3 Selecting the Channel of Operation The VT900-3’s video input presents a terminated 75-ohm load to the Referring to Figure 1, use a small flat-blade screwdriver to select the output of the video source device. Accordingly, no other device(s) besides channel (frequency) on which the transmitter will operate, by aligning the the VT900-3 should be connected to the video source.
- Page 4 Using the Combination Power/Video Connector(s) Transmitter Connection Diagram As an alternative to using standard audio and video interconnect cables, the VT900-3 transmitter and the VR900-3 receiver each provide a combination Power/Video connector on the unit’s rear panel. The pinout of these connectors is the same for both transmitter and receiver. For maximum range, transmitter and antenna must The pinout of the combination Power/Video/Audio jack, and its mating...
- Page 5 Channel 3 923 MHz For maximum range, the receiver’s Video Frequency Response* 0.5 – 4.0 MHz antenna must be oriented vertically. RF Output Power (VT900-3A) 1 mW (0 dBm) Operating Voltage 7.5 to 18VDC Rear panel of receiver Operating Current (VT900-3A)
- Page 6 INSTRUCTION TO THE USER (required by the FCC) Receiver Specifications (VR900-3) This equipment has been tested and found to comply with the limits for a Operating Frequency class B digital device, pursuant to part 15 of the FCC Rules. These limits Channel 1 907 MHz are designed to provide reasonable protection against harmful interference...
- Page 7 WHAT COVERED DURATION similarly alter products previously purchased. COVERAGE • APPLIED WIRELESS, INC. AW warrants the product to be free from EXCLUSION OF INCIDENTAL OR 1250 Avenida Acaso, Suite F defects in materials and workmanship for one CONSEQUENTIAL DAMAGES Camarillo, CA 93012...
-
Page 8: Troubleshooting Guide
United States of America monitor? Monitor/TV Setting Monitor mode set for viewing "line in" signal? © Copyright 2010 by Applied Wireless, Inc. All rights reserved. Specifications subject to change without notice. PPLIED IRELESS 1250 Avenida Acaso, Camarillo, CA 93012 Phone: 805-383-9600 Fax: 805-383-9001 Email: info@appliedwireless.com...
Need help?
Do you have a question about the VT900-3A and is the answer not in the manual?
Questions and answers